Using 30. years (1979-2009) of data from 33 automatic rain gauges in the Netherlands, a study of the space-time variability of rainfall is performed. This study uses 90-day averaged semi-variograms to find seasonal signals in the fitted spherical semi-variogram parameters of rainrates in the Netherlands, for accumulation intervals between 1 and 24. h. These signals can be well-described by simple cosine functions. The dependence of these cosine functions on the accumulation interval is modeled in two different ways: (1) power-law relations between the variogram parameters and the accumulation interval, and (2) power-law relations between the parameters of the cosine functions and the accumulation interval. For the first method the cosine function at the 24-h accumulation interval is also needed. The second of these methods has more parameters, but is shown to model the temporal scaling best. The space-time scaling relations found in this paper are compared to those found by others for similar and contrasting climates. Seasonality is shown to play an important role in determining rainfall spatial variability.@en

Quantitative precipitation estimation (QPE) using ground-based weather radar is affected by many sources of error. The most important of these are (1) radar calibration, (2) ground clutter, (3) wet-radome attenuation, (4) raininduced attenuation, (5) vertical variability in rain drop size distribution (DSD), (6) non-uniform beam filling and (7) variations in DSD. This study presents an attempt to separate and quantify these sources of error in flat terrain very close to the radar (1-2 km), where (4), (5) and (6) only play a minor role. Other important errors exist, like beam blockage, WLAN interferences and hail contamination and are briefly mentioned, but not considered in the analysis. A 3-day rainfall event (25-27 August 2010) that produced more than 50mm of precipitation in De Bilt, the Netherlands, is analyzed using radar, rain gauge and disdrometer data. Without any correction, it is found that the radar severely underestimates the total rain amount (by more than 50 %). The calibration of the radar receiver is operationally monitored by analyzing the received power from the sun. This turns out to cause a 1 dB underestimation. The operational clutter filter applied by KNMI is found to incorrectly identify precipitation as clutter, especially at near-zero Doppler velocities. An alternative simple clutter removal scheme using a clear sky clutter map improves the rainfall estimation slightly. To investigate the effect of wet-radome attenuation, stable returns from buildings close to the radar are analyzed. It is shown that this may have caused an underestimation of up to 4 dB. Finally, a disdrometer is used to derive event and intra-event specific Z-R relations due to variations in the observed DSDs. Such variations may result in errors when applying the operational Marshall-Palmer Z-R relation. Correcting for all of these effects has a large positive impact on the radar-derived precipitation estimates and yields a good match between radar QPE and gauge measurements, with a difference of 5-8 %. This shows the potential of radar as a tool for rainfall estimation, especially at close ranges, but also underlines the importance of applying radar correction methods as individual errors can have a large detrimental impact on the QPE performance of the radar.@en

Rain gauges can offer high quality rainfall measurements at their locations. Networks of rain gauges can offer better insight into the space-time variability of rainfall, but they tend to be too widely spaced for accurate estimates between points. While remote sensing systems, such as radars and networks of microwave links, can offer good insight in the spatial variability of rainfall they tend to have more problems in identifying the correct rain amounts at the ground. A way to estimate the variability of rainfall between gauge points is to interpolate between them using fitted variograms. If a dense rain gauge network is lacking it is difficult to estimate variograms accurately. In this paper a 30-year dataset of daily rain accumulations gathered at 29 automatic weather stations operated by KNMI (Royal Netherlands Meteorological Institute) and a one-year dataset of 10 gauges in a network with a radius of 5 km around CESAR (Cabauw Experimental Site for Atmospheric Research) are employed to estimate variograms. Fitted variogram parameters are shown to vary according to season, following simple cosine functions. Semi-variances at short ranges during winter and spring tend to be underestimated, but semi-variances during summer and autumn are well predicted.@en

This research is intended to improve on existing rainfall estimation algorithms derived from operational radar data as well as to facilitate the study of spatial and temporal variability of rainfall. Using the C-band radar data of the KNMI at De Bilt (the Netherlands) several operational products with a grid of 256 by 256 pixels are produced with a resolution of 2.5km × 2.5km from which precipitation characteristics can be derived. Commonly a single Z-R relation is applied on CAPPI fields to create an estimate of rainfall. The proposed algorithm tries to make a distinction between convective and stratiform precipitation types and therefore will offer a chance to improve upon the estimation of precipitation. First an algorithm based on reflectivity intensity is to provide a first guess of convective and stratiform areas. Secondly separate reflectivity areas (RAs) are identified and tracked in consecutive images to follow their development. Within the first step CAPPI, lightning, echo-top height and Vertically Integrated Liquid (VIL) data can be used to identify more accurately different precipitating areas. Future plans also involve incorporating volume scans directly into the algorithm.@en