Acrylonitrile butadiene styrene (ABS) and polycarbonate (PC) are considered a well-known class of engineering thermoplastics due to their efficient use in automotive, 3D printing, and elec-tronics. However, improvement in toughness, processability, and thermal stability is achieved by mixing together ABS and PC. The present study focuses on the understanding of surface mechanical characterization of acrylonitrile butadiene styrene (ABS) and polycarbonate (PC) blends using nano-indentation. Polymer blends sheets with three different proportions of ABS/PC (75:25, 50:50, and 25:75) were fabricated via melt-processing and thermal press. Fourier transform infrared (FTIR) spectroscopy was performed to analyze the intermolecular interactions between the blends’ compo-nents. To understand the surface mechanical properties of ABS and PC blends, a sufficient number of nano-indentation tests were performed at a constant loading rate to a maximum load of 100 mN. Creeping effects were observed at the end of loading and start of unloading section. Elastic modulus, indentation hardness, and creep values were measured as a function of penetration displacement in the quasi-continuous stiffness mode (QCSM) indentation. Load-displacement curves indicated an increase in the displacement with the increase in ABS contents while a decreasing trend was observed in the hardness and elastic modulus values as the ABS content was increased. We believe this study would provide an effective pathway for developing new polymer blends with enhanced mechanical performance.