Buoyancy-assisted upending of monopiles exceeding crane capacity
S.W. van Marwijk Kooij (TU Delft - Mechanical Engineering)
J.S. Hoving – Mentor (TU Delft - Civil Engineering & Geosciences)
T. Rossetto – Graduation committee member (TU Delft - Civil Engineering & Geosciences)
More Info
expand_more
Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.
Abstract
Offshore wind turbines keep growing, and so do the monopiles that support them, in diameter and mass. Increasingly often, the cranes on installation vessels in the current fleet will not have the crane capacity to upend these XXL monopiles. Floating upending, in which the monopile is rotated from horizontal to vertical while supported by its own buoyancy, could reduce the loads on the crane and may allow existing vessels to install monopiles that exceed their crane capacity. Its feasibility depends on the wave-induced response of the submerged monopile and the resulting crane force, which is insufficiently understood.
This research determines the wave-induced motions and crane forces during the upending of a floating monopile suspended from the crane hook alone, and assesses the resulting operability. Three monopiles of different mass are analyzed at fixed upending angles from horizontal (0°) to vertical (90°). The effect of entrapped water, a mass of water held in a compartment at the bottom of the monopile, on the response and operability is determined as part of this analysis. To obtain the monopile response and crane forces, the calm-water equilibrium is first determined at each upending angle, which gives the draft, inertia, and crane force. Two frequency-domain models in Ansys AQWA, one based on diffraction theory and one on the Morison equation, then determine the monopile response to waves around this equilibrium, and their results are compared. The resulting wave-induced crane forces are compared with a safe working load (SWL) of 900 tonnes and the off-lead and side-lead angle limits to determine the operability.
In calm water, the crane carries only 41 to 44% of the monopile weight. Under wave loading, the largest responses, and thus the lowest operability, occur at low upending angles of 15° to 30° , where the crane-monopile system resonates within the operability range, and the lever arm to the hooking point is large. For all angles, the operability is lowest at longer peak periods, as the sea state then lies closer to the resonance period. Two ways to increase the operability are examined. A higher SWL helps at short peak periods, where resonance has little influence, and has little effect at longer peak periods. Entrapped water reduces the calm-water crane force by 9 to 12%, but under wave loading it lowers
the operability at low angles, as the resonance period shifts towards the operability range, while it improves the operability at high angles, where the resonance period shifts away from it. The Morison equation-based model predicts a larger response than the diffraction model, increasingly so for larger monopile diameters and shorter waves. Over the full upending operation, it predicts an operability that is between 5 and 30% lower, depending on the monopile, mainly due to the 15° upending angle, which governs the operability.
Files
File under embargo until 19-11-2028