Complete Monopile Removal

Abstract

A large number of offshore wind turbines have been installed in recent years, and even
more are being erected in current and future projects. The majority of these turbines
have been or are being built of monopile foundations. Eventually, both the turbine and
the foundation have to be decommissioned. However, decommissioning options for
monopile foundations are limited, especially for complete removal of the foundation.
This thesis aims to study a new removal method patented by the company Iv-Consult,
which could potentially make entire monopile removal possible. The method uses
deformation of the monopile wall by a clamping tool to generate a vertical force. Since
the thesis served as a preliminary study into the removal method, it was chosen to limit
the scope of this study to the monopiles that are expected to be decommissioned in the
near future. With this information, a single case of monopile with dimensions that are
representative for these monopiles was presented. To analyse the removal method on the
case monopile the finite element method was used. In order to ensure results obtained
using the finite element method are accurate and representative, a convergence study was
carried out. To determine the element type and the mesh size that was the most suitable,
two different models were used: a ring model and a small cylinder model. Each was
studied using different combinations of inputs. After the results from the convergence
were obtained, these results were used on the models with which the removal method
was studied. Different configurations of the removal method were analysed with the
aim of maximizing the force that can be generated by the method to overcome resistance
forces. As a final step, the resistance forces that need to be overcome were calculated
for different soil types and compared to the results obtained from the removal method
models to verify the feasibility of the method.
From the results of the convergence study, it was shown that it is possible to model
the removal method using the finite element method and obtain representative results.
The final results of this thesis showed that clamping the monopile multiple times
does not have a positive influence on the vertical force that can be generated. This is
because clamping the monopile only once caused the highest vertical force. However, the
forces generated using the different setups of the clamping method were not sufficient
to overcome the resistance forces. This shows that the removal method in the current
configurations is not feasible, without applying any soil resistance reducing methods.