Modeling and analysis of a prestressed girder bridge prior to diagnostic load testing

Abstract

Progressive deterioration is a problem that affects road infrastructure, especially bridges. This requires the development of methods for its adequate detection and revision, one of them being load testing. Within load testing, finite element analysis (FEA) models provide initial information to understand the behavior of a structure and plan accordingly, which represents a fundamental step towards a precise structural evaluation of a bridge. This study focused on the modeling and analysis of the static response of the bridge over the river Lili in Cali, Colombia, a prestressed girder bridge programmed to undergo a diagnostic load test. A linear FEA model was created with information from a manual survey and from other bridges’ plans designed and built under the regulations in force at the time. Due to the absence of plans and design specifications for the bridge, variations were applied to certain model parameters (stiffness of diaphragms and elastomeric bearings), to quantify their effect on the overall behavior of the bridge. The analysis included obtaining the critical position for the design vehicles, the transversal distribution of stresses and determining the influence of the variation parameters in the response of the structure. Results showed that the critical combinations for bending moment and shear were when the loads were the closest to the exterior girders, being these elements the most affected. The variation on the modulus of elasticity for the diaphragms and the stiffness of the elastomeric bearings did not significantly influence the results for bending moment and shear, nor the critical position. Girder distribution factors (GDF) from the model were compared to previous research, finding similarities in shape and value with other FEA models and experimental results. Finally, an instrumentation plan focused on the girders of the bridge was proposed based on the zones where the maximum effects are expected. The findings in this study show how linear FEA models provide initial but relevant information regarding the critical position of design vehicles, the distribution of stresses and the expected values for bending moment and shear under design loads.