A Comparative Study of Thermo-Mechanical Fatigue Performance of Different Grades of SiMo Nodular Cast Iron
S. Shankar (TU Delft - Mechanical Engineering)
LAI Kestens – Mentor
R.H. Petrov – Graduation committee member
Ton Riemslag – Graduation committee member
Aakarshit Kalra – Graduation committee member
More Info
expand_more
Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.
Abstract
This thesis is a comparative study of the Thermo-Mechanical Fatigue (TMF) performance of different grades of SiMo nodular cast iron for heavy-duty diesel engine exhaust gas manifold applications. The TMF performance of the current SiMo variant used to manufacture exhaust manifolds - SiMo 5.10 (C-3.25Si-4.45Mo-0.76), is compared with that of the variants SiMo 4.05 (C-3.22Si-4.66Mo-0.56) and SiMoNi (C-3.3Si-4.5Mo-1Ni-1.3) by performing three out-of-phase (OP) TMF test series under partial constraint conditions. A benchmark TMF test series in the temperature range: 50 ˚C to 550 ˚C with a hold time of 30 s at 550 ˚C showed that SiMo 5.10 had relatively better performance due to development of lower mechanical crack driving forces compared to other variants. However, a long holding time of 600 s at 550 ˚C saw a larger decrease of average TMF lifetimes for SiMo 5.10 than that of SiMo 4.05 despite similar crack driving forces. An investigation of the stress relaxation during TMF of the two variants showed that the SiMo 4.05 performs better during long hold time due to better stress relaxation properties. The SiMoNi variant which is very brittle at low temperatures was found to fail by a fracture by overloading mechanism taking over quite early in the fatigue cycle; which is confirmed by examination of the fracture surfaces and numerical estimations. This also explained the low lifetimes and scatter in previously performed TMF tests under total constraint conditions. The TMF test series performed in the temperature range: 150 ˚C to 550 ˚C with a hold time of 30 s at 550 ˚C found that a heat-treatment seemed to reduce the TMF performance of the SiMo 5.10 variant. Metallographic investigations and hardness measurements of as-cast and heat-treated materials revealed that the distribution of the Mo-rich phase from the grain boundary regions into the matrix due to an annealing heat-treatment seemed to affect the TMF performance.