Detecting contact areas in vibrating steel beams using Energy Flux
M.H. van Dijk (TU Delft - Civil Engineering & Geosciences)
A. V. Metrikine – Mentor (TU Delft - Offshore Engineering)
V. Vaniushkina – Mentor (TU Delft - Offshore Engineering)
Sergio S. Gómez – Mentor
Thijs Kamphuis – Mentor (Delft Offshore Turbine)
More Info
expand_more
Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.
Abstract
The world faces an increasing energy problem, forcing people to search for sustainable energy sources. Offshore wind energy has shown great potential to financially compete with traditional energy sources. Recent developments like the slip-joint connection increase this potential. However, for further optimization of the design of a slip-joint, the location of the contact areas between the two cones must be known. Previous attempts to detect these contact areas based on techniques such as heat transfer or ultrasonic measurements have proven insufficient. A possible new way of detecting contact areas, is through the behaviour of Energy Flux. Energy Flux methods have shown great potential as a damping identification tool in other applications. Therefore, in this study the relation between Energy Flux behaviour and the presence of a contact point in the time-, frequency- and time-frequency-domain is studied. To this end, a numerical analysis of a vibrating simply supported Euler Bernoulli beam is conducted, simulating a contact area with a point load. The analysis in the frequency-domain showed the most promising results. Presence of a contact point (i) introduces peaks at twice the first and twice the second eigenfrequencies, and (ii) increases peak height at the location of the contact point. The pressure of the simulated contact point increased these effects. In the time-domain the presence of a contact point increased the amplitude of the cumulative energy flux. This change was most significant at the antinode of the first eigenmode. The location of the contact point was of little influence on this effect. These results show that the presence of a contact area influences the behaviour of the energy flux. The results are encouraging for a later implementation of the energy flux method for the detection of contact areas in a slip-joint. As a validation of these results, an experiment has been proposed. After execution of this experiment, further research is needed in (i) the behaviour of Energy Flux in a conical shape, and (ii) Energy Flux measurements of higher frequencies.