Effect of fabric architecture, compaction and permeability on through thickness thermoplastic melt impregnation
Julia Studer (University of Applied Sciences and Arts Northwestern Switzerland, Hamburg University of Technology)
C.A. Dransfeld (University of Applied Sciences and Arts Northwestern Switzerland, TU Delft - Aerospace Manufacturing Technologies)
Jon Jauregui Cano (University of Applied Sciences and Arts Northwestern Switzerland)
Andre Keller (University of Applied Sciences and Arts Northwestern Switzerland)
Marianne Wink (University of Applied Sciences and Arts Northwestern Switzerland)
K. Masania (ETH Zürich)
Bodo Fiedler (Hamburg University of Technology)
More Info
expand_more
Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.
Abstract
To reduce the cycle time of structural, automotive thermoplastic composites, we investigated the potential of direct thermoplastic melt impregnation of glass fabrics using an injection moulding process. At the high pressures that occur during the process, the effect of the fabric architecture on the impregnation, compaction, volume fraction and permeability of two unidirectional fabrics was studied. Using impregnation experiments with a low viscosity PA6 melt, we identified a favourable processing window resulting in an impregnation time of 5 min. The impregnation experiments with thermoplastic melts demonstrate that textile architectures promoting dual scale flow during impregnation are favourable for complete filling. Based on our findings, thermoplastic compression resin transfer moulding is an efficient processing route for automated production of composite parts with a high fibre volume fraction, if the fabric architecture is adapted for higher processing pressures and by fully utilising dual scale flow.
help_outline