Controlling adhesion between multi-asperity contacting surfaces in MEMS devices by local heating
A. Gkouzou (TU Delft - Micro and Nano Engineering)
Jaap Kokorian (TU Delft - Micro and Nano Engineering)
G.C.A.M. Janssen (TU Delft - Micro and Nano Engineering)
W. Merlijn van Spengen (TU Delft - Micro and Nano Engineering, Falco Systems)
More Info
expand_more
Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.
Abstract
In this work, we have incorporated heaters in a MEMS device, which allow the in situ local heating of its contacting surfaces. This design offers a promising solution for MEMS devices with contacting components by preventing capillary-induced adhesion. The force of adhesion was assessed by optically measuring in-plane snap-off displacements. We were able to decrease adhesion from 500 nN to 200 nN with just one heated surface of which the temperature was set above 300 °C. The temperature should not be set too high: we observed increased adhesion due to a direct bonding process once the temperature was increased above 750 °C. Remarkably, adhesion increased by heating from room temperature to 75 °C, which is attributed to more water being transferred to the contact area due to faster kinetics. We observed the same effect in the cases where both surfaces were heated, although at slightly different temperatures. We demonstrated that heating only one surface to between 300 °C and 750 °C is sufficient to significantly lower adhesion, due to the removal of capillary menisci. The required heater is typically most easily implemented in a stationary part of the device.
help_outline