Design of a turbine blade root connection with bushings

Abstract

With a growing demand for longer blades in the wind turbine industry for higher rated power per turbine, a structurally sound blade-root connection is of commercial importance. Bushing connections have been a commercially favoured design in the past few years, replacing the commonly used T-bolt connection as the joining method of choice. The new design replaces the barrel nut in the T-bolt with an axial bushing that the bolt connects to and can be assembled with the laminate during the lay-up stage of the blade skin. It has been theorised that it can result in a reliable connection due to the elimination of laminate stress concentrations. However, literature outlining the performance of a blade-root connection with bushings is lacking in the current body of knowledge. While several patents for bushing designs exist, they don’t provide verifiable results on their efficacy due to trademark laws. The objective of this project is to design and conduct a numerical study of a blade-root connection with bushings with an aim to replace the T-bolt connection, along with providing evidence of the effect of various parameters on the structural performance of the blade root. The design is to be based on a Suzlon Energy-make blade with a pitch circle diameter of 3m and a blade length of 63m. The project has been planned in three phases: (1) Design of the root; (2) Validation of the design; (3) Comparative analysis. Modelling and FE analysis has been carried out in the ANSYS environment. Parameters of the bolted connection have been determined according to industry standards provided by VDI and GL. Design validation was conducted based on structural constraints; the key design constraint relevant to the blade-root as a sub-component of the wind turbine is the accumulated fatigue damage. For the final phase of the study, various parameters associated with the assembled root were identified and tested in iterations and their effect on the structural performance, weight, and cost of the assembly were studied. The results confirm the hypothesis of reduction of stress concentrations within the laminate; this eliminates several failure modes associated with composite laminates at the blade root. As is, the bushing connection can be considered a viable alternative to the T-bolt joint. Within the connection, higher absolute stresses and stress gradients were developed in the bolt joining the blade to the hub. Hence, this was the area of focus for fatigue damage evaluations. Conservative estimates of the accumulated damage show values well within the acceptable range. The connection has been designed keeping several concurrent variables in mind. Given the commercial applicability of the design, a rigid optmized design is not feasible due to unpredictable parameters like certification costs, total assembly times, and procurement costs. Therefore, an effort has been made to understand the effect of varying component parameters. The design lends itself to flexibility of dimensioning and material choice within the sub-components; parameters can be optimised according to cost, manufacturability, and performance requirements. While the base design configuration for the bushing connection is heavier than the T-bolt design, improved fatigue performance can be seen as a favourable trade-off.