Searched for: +
(141 - 160 of 171)

Pages

document
Sharma, R. (author)
In this thesis, a stress recovery procedure for 3-D linear finite elements is presented. The formulation is based on a modified version of the Hu-Washizu variational principle, in which the recovered stresses are calculated by minimizing the error with respect to the directly-computed stresses, and ensuring that the recovered stresses satisfy...
master thesis 2016
document
Sharma, H. (author), Sietsma, J. (author), Offerman, S.E. (author)
Polymorphism is the ability of a solid material to exist in more than one phase or crystal structure. Polymorphism may occur in metals, alloys, ceramics, minerals, polymers, and pharmaceutical substances. Unresolved are the conditions for preferential nucleation during polymorphic transformations in which structural relationships or special...
journal article 2016
document
Feng, R. (author), Sharma, S. (author), Luthi, S.M. (author), Gisolf, A. (author)
Previously, Tetyukhina et al. (2014) developed a geological and petrophysical model based on the Book Cliffs outcrops that contained eight lithotypes. For reservoir modelling purposes, this model is judged to be too coarse because in the same lithotype it contains reservoir and non-reservoir lithologies. Hence, a new and more detailed geological...
conference paper 2015
document
Sharma, A. (author)
Boundary Layer Ingestion (BLI) is a concept in which the fuselage boundary layer is ingested by the engine to produce benefits like improved fuel efficiency, reduction of ram drag and lower structural weight of the configuration. Blended Wing Body (BWB) concept has been researched on and studied in various forms over the years as an efficient...
master thesis 2015
document
Kumar, D. (author), Sharma, A.R. (author), Goyal, T. (author), Shyam, V. (author), Mohite, P.M. (author), Kamle, S. (author)
Flapping wing micro air vehicles (MAVs) have the advantage of being able to fly at slow speeds and have high maneuverability. The design of a flapping wing MAV inspired by birds presents many technical challenges because birds as natural fliers exhibit higher efficiency than any man made flapping wing structure. Thus, the structure and motion of...
conference paper 2014
document
Sharma, D.M. (author), Poddar, K. (author)
Wind tunnel experiments were carried out at low speed aerodynamics lab at IIT Kanpur to investigate dynamic stall characteristics for a flow past an oscillating NACA 0015 airfoil at various reduced frequencies (k). The NACA airfoil model was design and developed to incorporate simultaneous surface pressure measurement at the mid-span of the...
conference paper 2013
document
Weerheijm, J. (author), Sharma, A. (author), Ozbolt, J. (author)
The behavior of concrete structures is strongly influenced by the loading rate. Compared to quasi-static loading, on meso and macro-scale concrete loaded by impact loading acts in a different way. First, there is a strain-rate influence on strength, stiffness, ductility, and, second, there are inertia forces activated which influence the...
conference paper 2013
document
Sharma, H. (author)
The research described in this thesis encompasses fields of 3DXRD, phase transformations and grain coarsening in iron alloys.
doctoral thesis 2012
document
Sharma, J. (author)
Nanotechnology has drawn a substantial amount of attention from policy makers and companies all across the globe. This research-intensive field is relatively in its early stages of commercialization. A plethora of large corporations and small-medium enterprises (SMEs) exists in different industries which harness nanotechnology to develop...
master thesis 2012
document
Sharma, K. (author), Ponomarev, M.V. (author), Verheijen, M.A. (author), Kunz, O. (author), Tichelaar, F.D. (author), Van de Sanden, M.C.M. (author), Creatore, M. (author)
In this paper, we report on the deposition of amorphous silicon (a-Si:H) films at ultra-high growth rate (11–60?nm/s) by means of the expanding thermal plasma technique, followed by solid-phase crystallization (SPC). Large-grain (?1.5??m) polycrystalline silicon was obtained after SPC of high growth rate (?25?nm/s) deposited a-Si:H films. The...
journal article 2012
document
Sharma, A. (author)
Flexible electronics is a fast emerging market and includes electronics fabricated on flexible substrates, large area displays, low cost and disposable electronics. Both research and commercial institutions around the world have been trying to develop low temperature processes which will enable fabrication of electronic devices on arbitrary...
master thesis 2012
document
Sharma, R. (author), Kim, T.W. (author), Storch, R.L. (author), Hopman, J.J. (author), Erikstad, S.O. (author)
journal article 2012
document
Kostenko, A. (author), Sharma, H. (author), Gözde Dere, E. (author), King, A. (author), Ludwig, W. (author), Van Oel, W. (author), Offerman, S.E. (author), Stallinga, S. (author), Van Vliet, L.J. (author)
This work presents the development of a non-destructive imaging technique for the investigation of the microstructure of cementite grains embedded in a ferrite matrix of medium-carbon steel. The measurements were carried out at the material science beamline of the European Synchrotron Radiation Facility (ESRF) ID11. It was shown that in-line X...
conference paper 2011
document
Mutikanga, H.E. (author), Sharma, S.K. (author), Vairavamoorthy, K. (author)
Water utilities particularly in the developing countries continue to operate with considerable inefficiencies in terms of water and revenue losses. With increasing water demand and scarcity, utilities require effective strategies for optimum use of available water resources. Diverse water loss reduction options exist. Deciding on which option to...
journal article 2011
document
Sharma, A.C. (author)
The thesis explores a strategic spatial proposal for a ‘Wetland Economic Zone’ in Mumbai’s salt-pan/ mangrove/ wetland area on Thane creek. The strategy questions the city’s blanket zoning attitude, and integrates primary sector economies like food production in sustainable practices but using the genius of the place, serving socio-economic...
master thesis 2011
document
Konishi, T. (author), Sagisaka, M. (author), Sharma, V.K. (author), Romero, J. (author)
The triple bottom line approach, focusing on "People Planet Profit" is based on environmental,economic and social criteria. To ascertain the sustainability of biomass utilisation, these aspects must be considered to overcome or minimise the problems. Then quantitative measures are needed for assessing impacts from environment, economic and...
conference paper 2010
document
Sharma, R. (author)
journal article 2010
document
Sharma, H. (author), Wattjes, A.C. (author), Amirthalingam, M. (author), Zuidwijk, T. (author), Geerlofs, N. (author), Offerman, S.E. (author)
We report a multipurpose furnace designed for studies using synchrotron radiation on polycrystalline materials, namely, metals, ceramics, and (semi)crystalline polymers. The furnace has been designed to carry out three-dimensional (3D) x-ray diffraction measurements but can also be used for other types of synchrotron radiation research. The...
journal article 2009
document
Sharma, H. (author)
master thesis 2008
document
Sharma, R. (author)
journal article 2008
Searched for: +
(141 - 160 of 171)

Pages