- document
-
Carrillo Córcoles, X. (author), Mertens, C. (author), Sciacchitano, A. (author), van Oudheusden, B.W. (author), De Breuker, R. (author), Sodja, J. (author)This study presents an aeroelastic wind-tunnel experiment to identify the influence of the wing stiffness and hinge release threshold on the gust load alleviation performance of a folding wingtip design. Five models with different stiffness and tailoring properties are tested, and the wing root bending moment at different conditions is compared...journal article 2023
- document
-
Schildkamp, R.R.M. (author), Chang, J. (author), Sodja, J. (author), De Breuker, R. (author), Wang, Xuerui (author)This paper proposes an incremental nonlinear control method for an aeroelastic system’s gust load alleviation and active flutter suppression. These two control objectives can be achieved without modifying the control architecture or the control parameters. The proposed method has guaranteed stability in the Lyapunov sense and also has...journal article 2023
- document
-
Carrillo Córcoles, Xavier (author)The flared folding wingtip (FFWT) is a concept presented by Airbus to increase the aerodynamic efficiency and provide a means of load alleviation. A gate-to-gate demonstration of this concept has already been presented with the AlbatrossONE, a scaled aircraft featuring the FFWT concept. In this demonstration, the aircraft fold the wingtips...master thesis 2022
- document
-
Schildkamp, R.R.M. (author), Wang, Xuerui (author), Chang, J. (author), De Breuker, R. (author), Sodja, J. (author)This paper presents the development and initial characterization of an active, para- metric wing section with aileron and spoiler control surfaces. This wing section is intended to replace the currently used passive wing section setup and facilitate research in active con- trol techniques of aeroelastic phenomena such as flutter, gust load...conference paper 2022
- document
-
Schildkamp, R.R.M. (author), Chang, J. (author), Sodja, J. (author), De Breuker, R. (author), Wang, Xuerui (author)This paper proposes an incremental nonlinear control method for aeroelastic sys- tem gust load alleviation and active flutter suppression. These two control objectives can be achieved without modifying the control architecture or the control parameters. The proposed method has guaranteed stability in the Lyapunov sense and also has robustness...conference paper 2022
- document
-
Wang, Z. (author), Peeters, D.M.J. (author), De Breuker, R. (author)This work presents a new aeroelastic optimisation framework for the preliminary design of variable stiffness composite wing structures. The framework is constructed by sequentially and iteratively solving two sub-problems: aeroelastic tailoring and lay-up retrieval, using gradient-based algorithms with full-analytical sensitivities provided....journal article 2022
- document
-
Rajpal, D. (author)The COVID-19 pandemic had a significant impact on the aviation industry with more than 60% reduction in the passenger traffic in the year 2020 compared to year 2019. The passenger traffic which is now expected to reach the 2019 level only around the year 2024 will still continue to grow but at a lower pace compared to the pre pandemic levels....doctoral thesis 2021
- document
-
Binder, S. (author), Wildschek, Andreas (author), De Breuker, R. (author)This paper presents an analysis of the interaction and trade-off between active aeroelastic control and passive structural tailoring on a free-flying fully flexible aircraft model. Both technologies are included in the preliminary design of a typical transport aircraft configuration with a conventional control surface layout containing...journal article 2021
- document
-
Rajpal, D. (author), Mitrotta, F.M.A. (author), Socci, C.A.M. (author), Sodja, J. (author), Kassapoglou, C. (author), De Breuker, R. (author)The aim of the paper is to experimentally validate a numerical design methodology for optimizing composite wings subject to gust and fatigue loading requirements and to assess the effect of fatigue on the aeroelastic performance of the wing. Traditionally, to account for fatigue in composite design, a knockdown factor on the maximum stress...journal article 2021
- document
-
Lancelot, P.M.G.J. (author), De Breuker, R. (author)In this paper, a methodology is presented to size an aircraft wing-box accounting for steady and dynamic loads combined with active control. Several aerodynamic corrections are used and benchmarked to ensure a consistent level of fidelity during the load analysis. Reduced order models (ROM) of the aircraft movables, gust loads and maneuvers...conference paper 2019
- document
-
Rajpal, D. (author), Gillebaart, E. (author), De Breuker, R. (author)Including a gust analysis in an optimization framework is computationally expensive as the critical load cases are not known a priori and hence a large number of points within the flight envelope have to be analyzed. Model order reduction techniques can provide significant improvement in computational efficiency of an aeroelastic analysis. In...journal article 2019
- document
-
Handojo, V.H. (author), Meddaikar, M.Y. (author), Dillinger, J.K.S. (author), Sodja, J. (author), De Breuker, R. (author)This paper presents a semi-experimental method which can be used to predict the gust response of a wind tunnel model. The method incorporates transfer functions of the wind tunnel model – in this case a flexible forward swept wing – which are obtained using sweep excitations with a gust generator. The prediction results are then compared with...conference paper 2019
- document
-
Rajpal, D. (author), De Breuker, R. (author)High aspect ratio strut braced aircraft can significantly reduce the induced drag. The inherent anisotropic behaviour of the composite material along with their weight saving potential can improve the performance of the aircraft during the flight. Thus, a composite strut braced aircraft is one of the promising candidates to achieve the...conference paper 2019
- document
-
Lancelot, P.M.G.J. (author), De Breuker, R. (author)The proposed approach in this paper aims to bring the accuracy of CFD to quick linear aeroelastic simulations for structural sizing. This is achieved by deriving reduced-order models (ROM) of the aircraft movables, gust loads and manoeuvres loads from rigid CFD analysis and to use these as substitutes for the loads in the aeroelastic simulation....conference paper 2018
- document
-
Bussemaker, Jasper (author)Improving the performance of large transport aircraft requires high aspect ratio and lightweight wings, making aeroelasticity an important factor in wing structural design. Active control of aeroelastic loads can be used to improve the aeroelastic behavior of the wing.<br/><br/>Two active load control techniques are considered: Maneuver Load...master thesis 2018
- document
-
Vink, W.J. (author), de Jonge, J.B. (author)The present report is part of a "Manual" on aircraft loads, that is being prepared by NLR. It contains a computer program, to be used in combination with "MATLAB4 for Windows" (Student Edition) software, to study aircraft loading due to turbulence. It includes a simple aircraft response model with two rigid and three flexible symmetric degrees...report 1997
- document
-
Wanhill, R.J.H. (author), Schra, L. (author)An investigation was made of the effect of starter notch geometry on flight simulation fatigue crack growth in three damage tolerant aluminium sheet alloys, 2024-T3, 2091-T84 and 8090-T81. Changing the starter notch geometry resulted in significant differences in initial nonstabilized fatigue crack growth behaviour. However, there was only a...report 1995
- document
-
Wanhill, R.J.H. (author), Schra, L. (author), 't Hart, W.G.J. (author)This report compares the mechanical properties, fracture toughness and fatigue crack growth properties of the damage tolerant/medium strength aluminium plate alloys 2024-T351, 2324-T39, 8090-T651 and 8090-T8171. The main objective, in view of previous work, was to determine whether damage tolerant 8090-T8171 plate can advantageously replace the...report 1995
- document
- de Jonge, J.B. (author), Hol, P.A. (author), van Gelder, P.A. (author) report 1995
- document
-
Noback, R. (author)Aspects of the requirements for and the calculation of design loads due to atmospheric disturbances are discussed. Special attention has been paid to the relation between discrete gusts and continuous turbulence. It is recommended that a worst case gust model, as described in this report, be further developed.report 1993