- document
-
ten Have, A.A. (author)WISPER and WISPERX are standardised variable-amplitude test loading histories for use in the fatigue design of horizontal axis wind turbine blades. They are based on flap load service measurements on 9 different horizontal axis wind turbines, covering a wide range of materials, rotor diameters and geographical locations. The present report is...report 1992
- document
-
't Hart, W.G.J. (author)The damage development In notched (± 45, 0„, 90, 0-) carbon-epoxy coupon specimens tested under different loading conditions was determined. Constant amplitude tests at R = -1 and R = 0.1 as well as flight simulation tests were performed to establish those stress values for which no damage growth occurs.report 1988
- document
-
Nederveen, A. (author), de Jong, J.B. (author)The influence of the approximation of the lower end of the load spectrum was investigated by comparative tests using the Basic F-27 test programme and an extended version, containing three times more cycles per flight. Crack growth was studied on notched sheet specimens made of Alclad 202U-T3 and Alclad TOT5-T6. Fatigue life tests were done on...report 1981
- document
-
van der Hoeven, W. (author), Schra, L. (author)The influence of sheet thickness (2 mm and 10 mm) and the influence of laminating (5x2 ram) on the fatigue crack growth properties of the aluminium alloy AL 7010-T 73651 were investigated. Both constant amplitude loading and flight simulation loading were applied. All 2 mm and 10 mm thick sheets were machined from a 150 mm thick plate, i.e....report 1981
- document
-
't Hart, W.G.J. (author), Schra, L. (author)The Al-Zn-Mg-Cu alloy 7050 produced by Alcoa is a typical plate and forging alloy because of its low quench sensitivity. In order to compare this alloy with the earlier tested plate alloy 7010 an experimental programme was performed involving tensile, fracture toughness, and fatigue testing. In addition stress corrosion crack initiation and...report 1980
- document
-
't Hart, W.G.J. (author), Nederveen, A. (author)Constant amplitude and flight simulation fatigue tests have been carried out on sulphuric acid, chromic acid and phosphoric acid anodized specimens. A comparison was made with the fatigue behaviour of bare sheet material. Before fatigue testing the fracture strain of the anodic layers was determined.report 1980
- document
-
Nederveen, A. (author), de Jonge, J.B. (author), Tromp, P.J. (author)The effects of systematic variations in mean stress level and in spectrum and ground load severity of a flight simulation test programme have been investigated on riveted specimens (fatigue life) and sheet specimens with central saw cut (crack growth). The fatigue life and crack propagation life in Alclad 202U-T3 compared with Alclad TOT5-T6...report 1980
- document
-
't Hart, W.G.J. (author), Schra, L. (author)An experimental investigation.was performed on 80 mm thick plate material of 7OIO-T7651 and 7OIO-T73651 developed by Alcan Industries Ltd in U.K. The testing programme involved: tensile tests, fracture toughness, stress corrosion and fatigue tests. For comparison a similar investigation vas carried out on 7075-T7351 Alcoa plate material.report 1979
- document
-
de Jonge, J.B. (author)Fokker-VFW is carrying out a completely new fatigue evaluation of the F-2T aircraft, covering lives up to 120000 flights. This evaluation includes; a)A complete inventory of the configuration status of the F-2T fleet, b)An inventory and evaluation of existing test experience, c)Evaluation of service experience, d)Analytical predictions of life...report 1978