Polymer-based composites have been drawing the attention of the research community for many decades, not only in academia but also in industry. However, continuously increasing environmental concerns have led the researchers to focus on natural composite materials. This is a challenge for researchers to develop a natural composite without compromising the composites’ excellent mechanical properties and tribological performance. In this research, coir and sugarcane are selected as the natural fillers, and epoxy resin has been chosen for matrix material. To look into the crystallinity of composites, XRD analysis was done. In addition, a mechanical study was done to look at the manufactured composites’ tensile and flexural characteristics. The tribological performance (i.e., wear rate and friction coefficient) of the composite samples is investigated by using a pin-on-disc setup. The parameters such as filler loading and normal load affecting the tribological performance of epoxy-based natural composites are studied. The results show that the wear and friction characteristics of the composite reinforced with sugarcane and coir were 10.78% and 57.80% lower than those of the neat composite, respectively.

This paper presents the dynamic responses of sandwich beams with 3D printed thermoplastic composite face sheets and multi-walled carbon nanotubes reinforced magnetorheological elastomer (MWCNT-MR elastomer) cores under non-uniform magnetic fields. A higher-order beam theory (HoBT) is employed to express the beam‘s displacement field. The governing equations of the 3D printed thermoplastic sandwich beam are derived using Lagrange‘s principle and discretized by the finite element method. The validity of the present method is confirmed through comparison with the results available in the literature. The stiffness and damping characteristics of the 3D printed thermoplastic sandwich beam are investigated in relation to support conditions, non-homogeneous magnetic flux, and core-face sheet thickness ratio.