Passenger cars contribute significant emissions in urban areas affecting the air quality of cities. Traditionally, vehicular emission factors (EFs) were developed based on measurements in the laboratory. However, studies indicate that the laboratory measurements are unrepresentative of real-world conditions. In this study, EFs were developed for diesel passenger cars using Portable Emission Measurement Systems (PEMS) on urban arterials with heterogeneous traffic conditions in Chennai, India. Three diesel passenger cars from different manufacturers, of the same age, and complying with Bharat Stage IV (BS IV) emission standards were selected for emission monitoring. The results show that the average carbon monoxide (CO), hydrocarbon (HC), and nitrogen oxides (NOx) emission factors of the passenger cars were 1.28, 0.13, and 0.59 g/km, respectively. In addition, the measured EFs were influenced by the road type with higher emissions on roads with higher speeds and steeper accelerations. Finally, the total annual emissions generated by diesel passenger cars in Chennai city, for the current vehicle activity, were estimated to 7000 tonnes of CO, 750 tonnes of HC, and 2400 tonnes of NOx. Considering the increasing emphasis on electric mobility and public transport, this study provides a timely insight into emissions from diesel passenger cars.@en

Motor vehicles contribute significantly to the total emissions in a city. Several studies have attempted to quantify emissions from cars, buses, and trucks using laboratory-based or real-world emission tests. However, real-world emissions from motorcycles (or motorized two-wheelers) has not received adequate attention. Unlike developed countries where cars are predominantly used for personal transport, motorcycles are widely used in developing countries. In this study, we quantify emissions of carbon monoxide (CO), hydrocarbons (HC), and nitric oxide (NO) from four typical motorcycles (MC 1, MC 2, MC 3, and MC 4) using real-world emission measurements and develop emission models. We also compare the observed real-world speed-time profiles with the laboratory test cycles and the emission factors developed using real-world emission measurements with the Bharat Stage (BS) emission standards. The real-world emission factors of CO for MC 1, MC 2, MC 3, and MC 4 were 12.3 times, 3.18 times, 9.71 times, and 5.84 times above the respective BS emission standard values. Also, the CO and [HC + NO] emissions from a two-stroke motorcycle (MC 1) were higher than the four-stroke motorcycles. The models presented in this paper can be used to accurately quantify real-world emissions from motorcycles on Indian urban arterials and to formulate policies for air quality improvement.@en

Road transport is a significant contributor of pollutant emissions in the cities of developing countries. Driving cycles are required for the estimation of fuel consumption and exhaust emissions from vehicles for emission testing and certification, with many cities having unique cycles for different types of vehicles and roads. However, no driving cycle has been developed for passenger cars and motorcycles in Chennai, India. Thus, the aim of the present study was to develop representative driving cycles for passenger cars and motorcycles which reflect the real-world driving conditions in Chennai, India. On-board diagnostic (OBD) reader and Global Positioning System (GPS) receivers were used to collect second-by-second vehicle speed from a representative set of vehicles for developing the driving cycles. Eleven assessment measures were used in the construction of the driving cycles from the micro-trips. The developed cycles for motorcycles and passenger cars were of 1448 and 1065 s (peak-hour), which were further compared with existing driving cycles. Significant differences were observed between the cycles, thus highlighting the need for city-specific cycles.@en