Last year’s mixed Sn–Pb perovskites have been applied as low-bandgap absorbers in efficient solar cells. However, the performance is still limited by tin oxidation, resulting in doping and defects. Here we perform a quantitative analysis on how tin oxidation affects the optoelectronic properties of spin-coated Cs_0.25FA_0.75Sn_0.5Pb_0.5I₃with varying SnF₂additions ranging from 0 to 20 mol %. First, optical spectroscopy is used to determine the fraction of Sn⁴⁺in the spin-coating solution, which varies depending on the purity of the starting SnI₂precursor. By applying steady-state microwave conductance, a large decrease in the dark conductivity from ∼100 to <∼1 S m^–1in the spin-coated films on going from 0 to 2 mol % SnF₂is observed. We conclude that, without SnF₂, ∼12% of the Sn⁴⁺in solution leads to mobile carriers in the form of free holes, p₀, in the perovskite layer. Upon SnF₂addition, p₀decreases to <1 × 10¹⁶cm^–3. We infer that a ∼70 times excess of SnF₂over the initial concentration of Sn⁴⁺in solution is required to scavenge the Sn⁴⁺and obtain layers with reduced doping. Although the reduction of p₀and defects results in increased carrier lifetimes, higher SnF₂additions are also required to decrease the surface defects, leading to even longer lifetimes close to 200 ns. The reduced doping of these perovskite films with SnF₂makes them ideal candidates for efficient solar cells; however, SnF₂also induces compositional heterogeneity and accumulation of SnO_xat the surface.