Riverbank filtration (RBF) represents a low-cost and sustainable alternative to advanced treatment technologies to pre-treat or remove several organic micropollutants (OMPs) from surface water. The objective of this research was to investigate the efficacy of biodegradation and adsorption processes in the removal of OMPs at high temperatures (20-30 ± 2 °C) during RBF. Laboratory-scale batch studies were conducted using silica sand at different temperatures (20, 25 and 30 °C) to study the removal of 19 OMPs (6 polyaromatic hydrocarbons (PAHs), 8 herbicides and 5 insecticides) from various water sources with different organic matter characteristics. Simazine, atrazine, metolachlor, and isoproturon exhibited partial persistent characters (16% < removal < 59%), which apparently decreased with increase in temperature. DDT, pyriproxyfen, pendimethalin, β-BHC, endosulfan sulfate and PAHs with high hydrophobicity (solubility in terms of logS < -4) tend to be well adsorbed onto sand grains (removal> 80%), regardless of temperature, redox conditions or type of organic carbon fraction fed to the batch reactors. These findings indicate that these hydrophobic compounds are effectively removed during RBF regardless of the environmental conditions. Hydrophilic compounds (molinate, dimethoate, and propanil) showed temperature-dependent characteristics for influent water with low organic matter; their attenuation increased at higher temperature (removal > 95%) due to the high microbial activity. This study revealed that temperature is an important parameter affecting the removal of OMPs with hydrophilic and low-hydrophobicity characters. However, temperature has less influence on the removal of highly hydrophobic OMPs during RBF process and thus should be considered during RBF system design.@en

Dissolved organic matter (DOM) in source water highly influences the removal of different contaminants and the dissolution of aquifer materials during bank filtration (BF). The fate of DOM during BF processes under arid climate conditions was analysed by conducting laboratory-scale batch and column studies under different environmental conditions with varying temperature (20-30 °C), redox, and feed water organic matter composition. The behaviour of the DOM fractions was monitored using various analytical techniques: fluorescence excitation-emission matrix spectroscopy coupled with parallel factor analysis (PARAFAC-EEM), and size exclusion liquid chromatography with organic carbon detection (LC-OCD). The results revealed that DOM attenuation is highly dependent (p < 0.05) on redox conditions and temperature, with higher removal at lower temperatures and oxic conditions. Biopolymers were the fraction most amenable to removal by biodegradation (> 80%) in oxic environments irrespective of temperature and feed water organic composition. This removal was 20-24% lower under sub-oxic conditions. In contrast, the removal of humic compounds exhibited a higher dependency on temperature. PARAFAC-EEM revealed that terrestrial humic components are the most temperature critical fractions during the BF processes as their sorption characteristics are negatively correlated with temperature. In general, it can be concluded that BF is capable of removing labile compounds under oxic conditions at all water temperatures; however, its efficiency is lower for humic compounds at higher temperatures.@en