Hard coastal structures such as dikes covered with asphalt or placed block revetments have been widely used in the past for coastal protection in densely populated deltas around the world. Nonetheless, in recent years the effectiveness of hard structures has been questioned in light of the inevitable effects of climate change and their static nature. Decades of research on how salt marshes can play a role within a comprehensive coastal protection scheme suggest that these low environmental impact structures (Maza et al., 2015) might have the capability of dissipating wave energy and hence be technically and formally considered within hybrid coastal erosion and flood protection systems (Borsje et al., 2011). However, only very few studies investigated wave attenuation by real salt marsh vegetation in large-scale laboratories (Ghodoosipour et al., 2022; Maza et al., 2015; Möller et al., 2014) and none of them addressed extreme hydrodynamic design conditions in terms of wave energy and water levels. As a result of this knowledge gap, salt marshes in The Netherlands and all around the world have never been formally considered within the coastal flood protection systems and the underlying risk assessment. With this contribution our aim is to provide an overview of the first worldwide large-scale test focused on the interaction between a salt marsh (i.e. vegetation and shallow foreshore) and extreme hydrodynamic conditions, the adopted measurement techniques and the preliminary results in terms of wave damping, erosion and removed biomass.

Overtopping wave loads on vertical structures on top of a dike have been investigated in several small scale experiments in the past. A large-scale validation for a mild foreshore situation is still missing. Hence the WALOWA experimental campaign was carried out to address this topic. In the present paper the objectives of the WALOWA project are outlined in detail, the model and measurement set-up described and the test program presented. Furthermore, preliminary results featuring a single 1000 irregular waves test of the test program are highlighted. This includes the study of the mild and sandy foreshore evolution by comparing profiles before and after the test execution. The profile measurements are obtained with a mechanical profiler. The wave parameters offshore and at the dike toe are numerically simulated using a SWASH model. The numerical results are validated against the measurements. Finally, the force and pressure time series of the waves impacting against the wall are processed and filtered. The load cell measurements and the time series of integrated pressures are compared to each other and for each impact event the maximum force is derived.