Coda wave interferometry is a technique used in the field of seismology, which utilizes the later part of the signal (coda) to detect subtle changes in a medium. In recent years, the application of coda wave interferometry to concrete structure has been assessed for structural health monitoring purposes. Smart aggregate is a sensor which consists of a piezoelectric sheet which is sandwiched between two marble layers which are meant to be used for structural health monitoring purposes by embedding it into concrete. However, its implementation for coda wave interferometry applications had not been attempted previously. In this research, the application of coda wave interferometry in concrete structures is explored further. The aim of this research is to assess the possibility of implementing coda wave interferometry to monitor the hydration process and the evolution of elasticity-modulus of concrete, as well as to learn how the wavespeed changes in concrete specimens subjected to cyclic loading in compression and bending. Additionally, seismic interferometry is also attempted to retrieve virtual impulse response to be used for coda wave interferometry. All experiments in this research utilize smart aggregates as transducers. By implementing coda wave interferometry, it is found that wavespeed does increase as concrete ages. This wavespeed increase can be linked to the evolution of elasticity-modulus of concrete, which enables its value to be monitored through the utilization of coda wave interferometry. It is also found that the use of embedded smart aggregate yields excellent reciprocity and stable correlation coefficient throughout the recording, while attached smart aggregates do not perform as well as the embedded ones in terms of reciprocity and correlation coefficient. Positive linear wavespeed change vs. stress and strain relationships in compressive samples are observed in lower stresses. In higher stresses, both wavespeed change vs. stress and strain display gradient reductions. Under repeated cyclic loadings, the loading phase of the first load cycle tend to have lower initial wavespeed change vs. stress and strain gradients compared to the following load steps, and the wavespeed change vs. stress and strain paths of reloading phases tend to follow the paths of their previous unloading phases. Wavespeed change vs. strain is more representative compared to wavespeed change vs. stress in depicting the compressive specimens’ condition due to the occurrence of permanent deformation during loadings. In a 10m-long beam specimen subjected to bending and shear, coda wave interferometry of later arrivals reveal decrease in wavespeed in the first loading phase of the test, while earlier arrivals show increase in wavespeed in the same phase. Moreover, it is possible to detect major crack formations by utilizing coda wave interferometry, which sensitivity is determined by the location of the cracks relative to the source-receiver sensors’ proximity. By assessing earlier arrivals of the signals recorded by smart aggregate implanted in the compression zone, the shift from uncracked to cracked section is observed through changes in wavespeed change vs load gradients. Seismic interferometry attempt was unsuccessful due to poor repeatability of the hammer hits and insufficient illumination to create diffuse wavefield.