Dynamic flavor release curves from chewing gum were measured using an Artificial Mouth coupled to the AFFIRM®. A flavor distribution model for chewing gum is proposed, where flavor is present as droplets in both the hydrophilic (water-soluble) and the hydrophobic (water insoluble) parts of the chewing gum and as molecularly dissolved in the hydrophobic part of the gum. During mastication, the flavor droplets in the water-soluble phase are released and responsible for an initial burst release. The flavor droplets captured in the gum-base are pushed towards the interface by mastication and are responsible for the subsequent release. The flavor molecules dissolved in the gum-base, released by diffusion, are only responsible for the release at very long time scales. It was found that the oil-water partition constant is an important parameter to explain the flavor release, where hydrophobic components show slower and longer release, while more hydrophilic components show more burst release.@en

Dense calcium caseinate dispersions can be transformed into hierarchically fibrous structures by shear deformation. This transformation can be attributed to the intrinsic properties of calcium caseinate. Depending on the dispersion preparation method, a certain amount of air gets entrapped in the sheared protein matrix. Although anisotropy is obtained in the absence of entrapped air, the fibrous appearance and mechanical anisotropy of the calcium caseinate materials are more pronounced with dispersed air present. The presence of air induces the protein fibers to be arranged in microscale bundles, and the fracture strain and stress in the parallel direction are larger compared with the material without air. The effects can be understood from the alignment of the fibers in the parallel direction, providing strain energy dissipation. This study shows that creation of anisotropy is the result of interactions between multiple phases.@en

Calcium caseinate dispersions can be transformed into anisotropic, fibrous materials using the concept of shear-induced structuring. The aim of this study is to further investigate the relative importance of air bubbles and protein on the mechanical anisotropy of calcium caseinate material. In this study, the effect of air on mechanical anisotropy of these fibrous materials was described with a load-bearing model, with the void fraction, and the bubble length and width as input parameters. The anisotropy of the protein phase was estimated using materials obtained from deaerated dispersions after shearing at different shear rates. We concluded that the deformation of air bubbles can only partly explain the mechanical anisotropy; the anisotropy of the protein phase is more important. Based on all results, we further concluded that the anisotropy of the protein phase was affected by the air bubbles present during the structuring process. This effect was explained by locally higher shear rate in the protein matrix during the structuring process.@en