The present work focuses on the sampling procedure and quantification of the PAH yield from the fast pyrolysis of waste softwood. In particular, fast pyrolysis experiments were conducted using a CDS Pyroprobe 5200 at temperatures between 500 °C and 1000 °C, at a heating rate of 600 °C/s for a sample size of 30 mg. High performance liquid chromatography (HPLC) was used for the determination of the PAH compounds present in the liquid sample fraction, while a micro – GC was employed for the analysis of the main gaseous products (CO, CO₂, CH₄ and H₂). An alternative tar sampling protocol was proposed, which employed the use of a cold trap (50 °C) and an isopropanol filled impinger bottle for the collection of the condensable products. The experiments were compared to heated foil reactor based pyrolysis tests within the same temperature range and heating rate, except for a slightly lower sample size (10 mg). The Pyroprobe and adapted sampling system proved to be more efficient regarding PAH capture and quantification compared to the heated foil reactor. Naphthalene, acenaphthylene and phenanthrene were the main PAH compounds detected. The PAH yields increased with pyrolysis temperature, up to values corresponding to roughly 0.2 wt% of the overall yield at 1000 °C. From the results it was derived that PAH evolution is mainly a product of secondary decomposition of primary tar, since the char yield stabilized for higher temperatures and the yields of CO, H₂ and CH₄ increased. Overall mass balance closure values were around 80 wt% on average. Char and gas yields were determined with high reproducibility, however gravimetric liquid analysis lacked due to the inability to gravimetrically measure the yield condensing in the impinger bottle. Future work is aimed on improving on this particular aspect. Overall, the alternative tar sampling system proposed was successful in the quantification of PAH from biomass fast pyrolysis experiments offering increased flexibility, accuracy and practicality of use.