The optical absorption of water-containing bio-fuel is investigated as a parameter to determine the gasoline content of this fuel. Optical measurements reveal that gasoline shows an interesting and useful spectrum with typical absorption behavior in the UV range between 230 and 300 nm. This result indicates that significant information can be obtained to determine the gasoline concentration in bio-fuel by UV absorption spectroscopy. A concept for a low-cost measurement system in the fuel line is presented, by implementing a LVOF in combination with a wide-band light source and detector arrays.@en

A capacitive probe is generally used in a flex-fuel engine for measuring the ethanol content in biofuel. However, the water content in biofuel of high ethanol content cannot be disregarded or considered constant and the full composition measurement of ethanol, gasoline and water in biofuel is required. Electrical impedance spectroscopy with a customized capacitive probe operating in the 10 kHz to 1 MHz frequency range is combined with optical absorption spectroscopy in the UV spectral range between 230 and 300 nm for a full composition measurement. This approach is experimentally validated using actual fuels and the results demonstrate that electrical impedance spectroscopy when supplemented with optical impedance spectroscopy can be used to fully determine the composition of the biofuel and applied for a more effective engine management. A concept for a low-cost combined measurement system in the fuel line is presented.@en

Measuring the ethanol/water ratio in biofuel of high ethanol content, such as E85, is important when used in a flex-fuel engine. A capacitive probe is generally used for measuring the ethanol/gasoline ratio. However, the water content in E85 biofuel cannot be disregarded or considered constant and full composition measurement of biofuel is required. Electric impedance spectroscopy with a customized coaxial probe operating in the 10 kHz to 1 MHz frequency range was investigated. An in-depth investigation of the electrical impedance domain has led to the conclusion that additional information is required to unambiguously determine the composition of the ternary biofuel mixture. Among the different options of measurement domains and techniques, optical absorption spectroscopy in the UV spectral range between 230 and 300 nm was found to be the most appropriate. The typical absorbance in the UV range is highly dominated by gasoline, while ethanol and water are almost transparent. This approach is experimentally validated using actual fuels.@en