Drones are unmanned flying vehicles, which can be used for a broad spectrum of different applications. One of these applications is the generation of albedo maps. However, it could take some time to map an area. Therefore problems can occur the with respect to its flight range, which typically lies between 20 to 45 km for mini UAVs. The goal of this project is to design a PV powered drone that can create an albedo map of an area that is equal or bigger than the area of the Technical University of Delft. This is done by choosing and modelling an UAV system, where after choosing and modelling a PV generator system. Based on these models, power dynamics and flight ranges are calculated. The usability is tested for different weather conditions of Delft. The UAV system with PV generator without protection layers has a flying range between 129 and 250 km, depending in the irradiance. For the same system with protective layers, the flight range varies from 117 to 208 km. the total flight range that is needed to map the area of the TU Delft is 48.75 km. Therefore, there can be concluded that in both cases our goal has been achieved. When these results are compared to the weather conditions of the TU Delft, it can be concluded that on average a UAV system with PV generator will increase the flight range. However, when comparing this system to a system with additional batteries, the latter will achieve better results. In order to make sure that the PV generator system will guarantee a longer flight range, limitations regarding times, periods and places are made. Keep in mind that since these results are solely based on models of systems, it's best to create and test the physical system to validate the found results.

This thesis is written in context of the Bachelor Graduation Project. We would like to express our gratitude to our daily supervisor Patrizio Manganiello and our supervisors Andres Calcabrini and Mirco Muttillo for their guidance during the project.  Finally we would like to thank our colleagues: Laura Muntenaar and Sjoerd de Groot of the control algorithm project and Jetse Spijkstra and Martin Geertjes of the power electronics project for an enjoyable and productive collaboration.

J. Koning & R. van der Hoorn
Delft, June 2020