Accurate estimation of urban land surface temperature (ULST) is critical for studying urban heat islands, but complex three-dimensional (3D) structures and materials in urban areas introduce significant adjacency effects into remote sensing retrievals. To investigate the influence of different factors on the adjacency effects, this study employed the DART model to quantify brightness temperature differences (ΔTb) of urban pixels by comparing their simulated radiance in two scenarios: (1) an isolated state (no adjacent buildings) and (2) an adjacent state (with surrounding buildings). ΔTb, representing the adjacency effect, was systematically analyzed across spatial resolutions (1–120 m), building geometry (building height BH, roof area index (Formula presented.), adjacent obstruction degree SVF_Obs.), and material reflectance (reflectance R = 0.05, 0.1, 0.15) to determine key influencing factors. The results demonstrate that (1) adjacency effects intensify significantly with higher spatial resolution (mean ΔTb ≈ 5 K at 1 m vs. ≈2 K at 30 m), with 60–90 m identified as the critical resolution range where the adjacency-induced error is attenuated to a level (ΔTb < 1 K) that is commensurate with the intrinsic uncertainty of current mainstream ULST algorithms; (2) increased building height, reduced density ((Formula presented.)), and greater adjacent obstruction (SVF_Obs.) exacerbate adjacency effects; (3) material emissivity (ε = 1 − R) is the dominant factor, where low-ε materials (high R) exhibit markedly stronger adjacency effects than geometric influences (e.g., ΔTb at R = 0.15 is approximately three times higher than at R = 0.05); and (4) temperature differences among surface components exert minimal influence on adjacency effects (ΔTb < 0.5 K). This study clarifies key factors driving adjacency effects in high-resolution ULST retrieval and defines the critical spatial resolution for simplifying inversions, providing essential insights for accurate urban temperature estimation.

Vegetation indices, especially the normalized difference vegetation index (NDVI), are widely used in urban vegetation assessments. However, estimating the vegetation abundance in urban scenes using the NDVI has constraints due to the complex spectral signature related to the urban structure, materials and other factors compared to natural ground surfaces. This paper employs the 3D discrete anisotropic radiative transfer (DART) model to simulate the spectro-directional reflectance of synthetic urban scenes with various urban geometries and building materials using a flux-tracking method under shaded and sunlit conditions. The NDVI is calculated using the spectral radiance in the red (0.6545 μm) and near-infrared bands (0.865 μm). The effects of the urban material heterogeneity and 3D structure on the NDVI, and the performance of three NDVI-based fractional vegetation cover (FVC) inversion algorithms, are evaluated. The results show that the effects of the building material heterogeneity on the NDVI are negligible under sunlit conditions but not negligible under shaded conditions. The NDVI value of building components within synthetic scenes is approximately zero. The shaded road exhibits a higher NDVI value in comparison to the illuminated road because of scattering from adjacent pixels. In order to correct the effects of scattering caused by building geometry, the reflectance of the Landsat 8/OLI image is corrected using the sky view factor (SVF) and then used to calculate the FVC. Jilin-1 satellite images with high spatial resolution (0.5 m) are used to extract the vegetation cover and then aggregated to 30 m spatial resolution to calculate the FVC for validation. The results show that the RMSE is up to 0.050 after correction, while the RMSE is 0.169 before correction. This study makes a contribution to the understanding of the effects of the urban 3D structure and material reflectance on the NDVI and provides insights into the retrieval of the FVC in different urban scenes.