Influence of injection conditions on feedstock flowability for µMIM.

Influence of WEDM-EDM of AlSi7Mg/Al2O3 composite on its technological characteristics after Electro Discharge Machining (EDM).

Surface properties of AlSi7Mg/Al2O3 composite after electro discharge machining (EDM).

Poster: Influence of silicon content in Al-XSi-Y alloys on surface quality after EDM (Electro-Discharge Machining).

Influence of silicon content in Al-XSi-Y alloys on surface quality after EDM (Electro-Discharge Machining).

EDM of aluminium matrix composites reinforced with Si3N4 particles.

Influence of reinforcing phase in aluminium matrix composites on surface geometry after Electrodischarge Machining (EDM).

Electro-discharge machining of a P/M Al-30Si-X alloy for electronic packaging.

Electro-discharge machining of a P/M Al-30Si-X alloy for electronic packaging.

The tribological characteristics of the Al-20Si-3Cu-1Mg alloy reinforced with Al2O3 particles in relation to the hardness of mating steel.

Wear resistance of hard composite coatings.