Urban stormwater is sometimes a risk, sometimes a resource. To address both aspects, the Three Points Approach (3PA) is advocated. This research applied the 3PA to map stormwater approaches in two Chinese and four European cities. While all cities have targets for the Technical Design Domain, none have targets for all domains; and thereby lack interventions to maximize benefits of frequent small events in the Day-to-Day Domain or minimize flood risks of rare large events in the Extreme Domain. Using open global precipitation data cities’ stormwater targets were expressed as more comparable rain depths, demonstrating that event depths within the Day-to-Day Domain in Chinese cities, cover much of the same range as those within the Technical Design Domain in the European cities. Expressing targets as depths in the context of the 3PA framework may facilitate transdisciplinary and transnational knowledge sharing, paving the way for management strategies covering all three domains.

The effect of thermal aging of homogenized Fe-Au and Fe-Au-W alloys, irradiated at room temperature with hydrogen ions, was studied for an aging treatment at 300 °C for aging times up to 100 h. The aging behavior of the Fe-based alloys is compared to the results for pure Fe. The precipitation behavior of Au-rich and W-rich precipitates and its correlation to the H⁺ irradiation-induced defects is investigated by variable energy positron annihilation spectroscopy (VEPAS). The formation of open-volume defects after irradiation is monitored by an increase in the S parameter, while the recovery of the vacancy-like defects and the formation of precipitates are signalled by an increase in the W parameter. Au-rich precipitation continuously develops during long-term aging, as indicated by the increase in the W parameter. The change of the W parameter in the Fe-Au-W alloy is not only due to the effect of solute W on the Au precipitates, but also because of the interface of W-rich Laves phase with matrix.

Microporosity in carbonate reservoirs is globally pervasive and commonly used to explain high-porosity, low-permeability reservoirs, higher than expected water saturations, low resistivity pay zones and poor sweep efficiency. The potential for micropores to store and produce hydrocarbons has long been recognized, yet limitations on tools to evaluate microporosity has prevented rigorous evaluation. Here we demonstrate a workflow for evaluating microporosity through a combination of laser scanning confocal microscopy (LSCM) and pore network modelling. Specific values for microporosity and permeability calculated in our study should not be applied explicitly, as these are simulated values, but they demonstrate the viability of micropore networks to store and flow hydrocarbons. Carbonate reservoir assessment is critical not only in the petroleum industry, but also for applications in hydrothermal and mineral resources, carbon capture and storage, and groundwater supply. This approach can be applied to understand the potential for any reservoir to hold and transmit fluids.