Observations of two typical contrasting weakly stable and very stable boundary layers from the winter at Dome C station, Antarctica, are used as a benchmark for two centimetre-scale-resolution large-eddy simulations. By taking the Antarctic winter, the effects of the diurnal cycle are eliminated, enabling the study of the long-lived steady stable boundary layer. With its homogeneous, flat snow surface, and extreme stabilities, the location is a natural laboratory for studies on the long-lived stable boundary layer. The two simulations differ only in the imposed geostrophic wind speed, which is identified as the main deciding factor for the resulting regime. In general, a good correspondence is found between the observed and simulated profiles of mean wind speed and temperature. Discrepancies in the temperature profiles are likely due to the exclusion of radiative transfer in the current simulations. The extreme stabilities result in a considerable contrast between the stable boundary layer at the Dome C site and that found at typical mid-latitudes. The boundary-layer height is found to range from approximately 50m to just 5m in the most extreme case. Remarkably, heating of the boundary layer by subsidence may result in thermal equilibrium of the boundary layer in which the associated heating is balanced by the turbulent cooling towards the surface. Using centimetre-scale resolutions, accurate large-eddy simulations of the extreme stabilities encountered in Antarctica appear to be possible. However, future simulations should aim to include radiative transfer and sub-surface heat transport to increase the degree of realism of these types of simulations.@en

In polar regions, where the boundary layer is often stably stratified, atmospheric models produce large biases depending on the boundary-layer parametrizations and the parametrization of the exchange of energy at the surface. This model intercomparison focuses on the very stable stratification encountered over the Antarctic Plateau in 2009. Here, we analyze results from 10 large-eddy-simulation (LES) codes for different spatial resolutions over 24 consecutive hours, and compare them with observations acquired at the Concordia Research Station during summer. This is a challenging exercise for such simulations since they need to reproduce both the 300-m-deep convective boundary layer and the very thin stable boundary layer characterized by a strong vertical temperature gradient (10 K difference over the lowest 20 m) when the sun is low over the horizon. A large variability in surface fluxes among the different models is highlighted. The LES models correctly reproduce the convective boundary layer in terms of mean profiles and turbulent characteristics but display more spread during stable conditions, which is largely reduced by increasing the horizontal and vertical resolutions in additional simulations focusing only on the stable period. This highlights the fact that very fine resolution is needed to represent such conditions. Complementary sensitivity studies are conducted regarding the roughness length, the subgrid-scale turbulence closure as well as the resolution and domain size. While we find little dependence on the surface-flux parametrization, the results indicate a pronounced sensitivity to both the roughness length and the turbulence closure.@en