Stirring has been recognized in the literature as a promising technique for facilitating fluidization of cohesive powders, via inputting additional energy to counteract interparticle forces. However, the influence of operating conditions and stirrer configurations on flow behavior remains largely unknown, which impedes the practical implementation of stirred fluidization. Utilizing X-ray imaging, this research demonstrates that stirring enhances fluidization in cohesive micron-silica powder (Sauter mean diameter [Formula presented]) by collapsing the powder packing structure, and transitioning channeling beds into bubbling states. Comb-like configurations featuring fewer stirrers and blades, placed in the bottom region, have shown to be highly effective. Excessive stirring can lead to air pockets and a compacted phase of particles on the column walls, undermining the interaction between particles and stirrers. Additionally, the experiments show that maximizing the sweeping coverage, employing complex asymmetrical configurations, and avoiding tortuous gas pathways are preferable.

Mechanical vibration has been broadly used to assist fluidization of cohesive powders, because of its capability to disrupt gas channels and agglomerates. However, the improvement reported in literature is mostly deduced from bulk response and ex-situ measurements, whereas the induced fluidization behavior and underlying physics remain largely unexplored. In this work, the fluidization behavior of micron-sized cohesive silica (Sauter mean diameter D₃₂ = 7.9 μm) has been investigated experimentally under vibration of varying conditions. X-ray imaging was carried out to directly capture the temporal evolution of system hydrodynamics, and identify in-situ powder stratification, bubbling and channel formation. The study demonstrates that vibration effectively collapses gas channels, yet facilitates powder stratification and compaction, therefore developing three distinctive flow regions inside the bed with different fluidization states. Consequently, common measurements, such as pressure drop and bed expansion, tend to overestimate the improvement. In addition, increasing frequency, from 10 Hz to 30 Hz, is observed to increase the number of bubbles by 60 %, whereas a large amplitude (e.g., 2 mm) leads to a 10 % compaction in the top flow region.