As the world transitions to renewable electrification to reduce CO2 emissions, remote island electrification remains a challenge. Although some islands are connected to the grid, many still rely on fossil fuels for electricity generation. Several studies indicate that renewable energy sources, such as wave energy, have the potential to make these islands self-reliant because of their substantial power potential. However, research on the control of power electronics converters for these systems remains limited. This paper proposes isolated grid-forming control for island electrification to address this gap using a wave energy converter and an energy storage system. Resistive loading control is implemented to optimize the power absorption of the generator. The result illustrates the establishment of the required AC voltage and 50 Hz frequency in the island load, ensuring harmonics compliance with the recommended standards. Experiments were conducted to test and validate the operation of different converter controls. The results also demonstrate the converter's ability to black-start the island load and automatically transition the load current with varying loads in a few milliseconds. Furthermore, the power quality produced by the wave energy converter presents one of its significant challenges. Therefore, the performance of two distinct converter technologies was compared. The performance of the IGBT converter was evaluated against that of the SiC-based converter in terms of power quality. The study demonstrates that the use of SiC enhances power quality in all switching frequencies tested, achieving the most significant reduction of 78% in current THD and 92% in voltage THD at the 25 kHz switching frequency, thus validating its advantages for wave energy converter applications.

Decarbonization of ports is a major goal to reduce their global carbon footprint. The port of Hvide Sande is located on the coast of the North Sea in Denmark and it has the potential to utilize various renewable energy sources. Wind and solar thermal parks are already installed there. Wave energy is an alternative to solar and wind energies and its advantage is the spatial concentration, predictability, and persistence. Heat to the town is provided by Hvide Sande Fjernvarme. In this work, it is investigated if the heat demand could be fully covered by renewable energies. Power profiles for each renewable energy resource were calculated using 30 years of re-analysis environmental data. Long, mid, and short term time series of power supply has been statistically and quantitatively examined. Considering the heat demand of Hvide Sande, the lowest frequency of zero occurrence in power generation can be ensured by the combination of wind, solar energy and wave. The article also estimated the capacity for Lithium-ion batteries. The optimal size of the battery is found by the bisection method. Finally, different combinations of renewable energy and demand as well as batteries are evaluated. The lowest zero occurrences in power production is met by the mix of three renewable energies. Also, the mix of three renewable energies significantly reduces the value of energy, required from the battery.