The Covid-19 pandemic causes imminent shortages of face masks in hospitals globally. In preparation for that scarcity we performed a study to investigate the possibility of reprocessing disposable FFP2 face masks in order to verify their re-usability with a method that could be applied in practice using already available equipment. Therefore single use FFP2 masks (type 1862+3MTM) were sterilized with a 15-minute procedure at 121 ⁰C, using a dry sterilization process as well as with a regular steam process with the masks in sterilization/laminate bags. The effectiveness of these processes are sufficient to inactivate the coronavirus based on the knowledge of inactivation of such viruses. [1,2] A blind comparison of unused sterilized masks was performed with respect to visual inspection, consistency, face fit and breathing resistance. The results of this comparison were that the investigators were unable to distinguish unused new (slightly curved and folded) masks from reprocessed sterilized masks.@en

Background: There is a worldwide shortage of medical-grade face masks. Donning masks can play an important role in curbing the spread of SARS-CoV-2. Aim: To conclude whether there is an effective mask for the population to wear in public that could easily be made during a medical face mask shortage using readily available materials. Methods: We determined the effectiveness of readily available materials and models for making a face mask. The outcomes were compared with N95/FFP2/KN95 masks that entered the Netherlands in April–May 2020. Masks were tested to determine whether they filtered a minimum of 35% of 0.3-μm particles, are hydrophobic, seal on the face, are breathable, and can be washed. Findings: Fourteen of the 25 (combinations of) materials filtered at least 35% of 0.3-μm particles. Four of the materials proved hydrophobic, all commercially manufactured filters. Two models sealed the face. Twenty-two of the 25 materials were breathable at <0.7 mbar. None of the hydrophobic materials stayed intact after washing. Conclusions: It would be possible to reduce the reproduction rate of SARS-CoV-2 from 2.4 to below one if 39% of the population would wear a mask made from ePM₁ 85% commercially manufactured filter fabric and in a duckbill form. This mask performs better than 80% of the imported N95/FFP2/KN95 masks and provides a better fit than a surgical mask. Two layers of quilt fabric with a household paper towel as filter is also a viable choice for protecting the user and the environment.@en