Adhesive joining of carbon fibre reinforced polymer (CFRP) is cumbersome due to the careful surface preparation required and multiple validation steps to certify adhesion quality. Further these joints are often supplemented by mechanical fastenings add weight whilst also localising bearing stress. As an alternative technique, CFRP parts can be functionalized with thermoplastic surfaces during manufacture to enable cost-effective welding of composite structures. In the process of manufacturing the CFRP, curing an epoxy resin in the presence of the functionalising thermoplastic polymer can lead to local dissolution of the latter in the epoxy, followed by a reaction-induced phase separation. This results in a thermosetting-thermoplastic interphase featuring gradient concentrations and a multiphase morphology, which promotes load transfer between the thermosetting matrix and the thermoplastic joint. The aim of the work presented in this paper was to investigate interphase formation between high-Tg epoxy and polyetherimide (PEI) at different curing temperatures. The morphology was characterised using scanning electron microscopy and the composition of the interphase was quantified through Raman spectroscopy. The curing experiments indicated that temperature has a significant effect on the interphase morphology and led to two different biphasic morphologies which generally increased in size with increasing curing temperature. This suggests that the size of the gradient interphase can be tailored through the curing process, which is as a fundamental step in optimising the structural performance of welded joints with PEI-functionalized epoxy-based CFRPs.@en