The present paper gives a concise overview of a number of current issues in the literature on texture formation in alloys with cubic crystal structures, mainly steel and aluminium alloys. As crystallographic texture determines to a large extent the anisotropy of material properties, it is of paramount importance to understand and control the physical mechanisms by which the texture is formed in the subsequent stages of metals manufacturing processes. In the present overview three key solid-state transformation processes are considered: allotropic phase transformations, plastic deformation and recrystallisation. The intention is to highlight a number of key elements in the literature and some recent tendencies, which may provide some insight to scientists and engineers dealing with texture issues in daily practice.

@en

Manual serial sectioning which includes consecutive steps of sample preparation and Electron Back Scattering Diffraction (EBSD) measurement was employed to extract the twodimensional (2D) sections of a pure nickel sample and to reconstruct the three-dimensional (3D) microstructure. A general alignment algorithm based on the minimization of misorientation between two adjacent sections has been developed to accurately align the sections. By employing this alignment algorithm, any in-plane (translational) and rotational misalignment as well as the planparallelity can be corrected. Surface triangulation technique was used to reconstruct the grain boundary surfaces. The Grain Boundary Character Distribution (GBCD) was derived from reconstructed grain boundaries. The results show that a smoother grain boundary plane can be obtained after precise translational and rotational alignment and correction of planparallelity. The relative grain boundary energy was computed as a function of the five grain boundary parameters based on equilibrium at triple lines. The results show that the grain boundary planes carrying a Σ3 type misorientation are dominantly parallel to the {111} crystal plane, which indicates the presence of coherent twin boundaries. It was observed that coherent Σ3 type boundaries exhibit the minimum relative grain boundary energy, which is approximately 57% smaller than the average of all Σ3 boundaries, including also incoherent twin boundaries.@en