F.O. Annor
Please Note
15 records found
1
This study investigates if Ethiopia’s energy pathways benefit from adding pumped hydro storage, suitable regions for PHS, and to what extent storage would increase system resilience. The long-term energy planning tool OSeMOSYS is used, which allows for detailed investigation into system dynamics whilst parallelly minimising costs. OSeMOSYS enabled the investigation into Ethiopia by looking at an extensive host of techno-economic specifications and supply and demand dynamics from the electrification of transport and integration of variable renewables to residential cooking demands.
This research studies thirteen scenarios which are separated into three main categories: Base Case (3), Emission Penalty (EMI) (6) and Varying Wind Capacity and Seasonality (WND) (6). The base case introduces pumped storage to the energy pathways, and the EMI scenario characterises three pathways for carbon pricing. In the WND scenario, wind power’s capacity factor and seasonality are altered to investigate the potential effects of using more accurate local data or prioritising some supply zones on the energy system configuration. Additionally, the most favourable locations for solar PV and wind are combined with potential PHS locations to find optimal sites for storage construction.
The results of the research show that pumped hydro storage is adopted into the energy system in all scenarios, following both a diurnal and seasonal (dis)charge pattern. Variable renewable integration increases by an average of 10% from the addition of storage (78 GWh). The emission penalty increases the electrification of residential cooking demand and boosts VRE penetration but does not integrate storage integration further than the base case due to reaching the upper limit of the storage capacity set in the planning experiments.
Pumped hydro storage was found to increase the resilience of the modelled energy systems to climate-driven seasonal uncertainties and prices due to fossil fuel and carbon price uncertainties by making them less dependent on fossil fuels, decreasing vulnerability for potential emission penalties, and seasonal capacity fluctuations. The introduction of PHS was also found not to increase overall system costs, making it, combined with the stable levelised cost of storage and high maturity, a prime candidate for large-scale energy storage in Ethiopia. ...
This study investigates if Ethiopia’s energy pathways benefit from adding pumped hydro storage, suitable regions for PHS, and to what extent storage would increase system resilience. The long-term energy planning tool OSeMOSYS is used, which allows for detailed investigation into system dynamics whilst parallelly minimising costs. OSeMOSYS enabled the investigation into Ethiopia by looking at an extensive host of techno-economic specifications and supply and demand dynamics from the electrification of transport and integration of variable renewables to residential cooking demands.
This research studies thirteen scenarios which are separated into three main categories: Base Case (3), Emission Penalty (EMI) (6) and Varying Wind Capacity and Seasonality (WND) (6). The base case introduces pumped storage to the energy pathways, and the EMI scenario characterises three pathways for carbon pricing. In the WND scenario, wind power’s capacity factor and seasonality are altered to investigate the potential effects of using more accurate local data or prioritising some supply zones on the energy system configuration. Additionally, the most favourable locations for solar PV and wind are combined with potential PHS locations to find optimal sites for storage construction.
The results of the research show that pumped hydro storage is adopted into the energy system in all scenarios, following both a diurnal and seasonal (dis)charge pattern. Variable renewable integration increases by an average of 10% from the addition of storage (78 GWh). The emission penalty increases the electrification of residential cooking demand and boosts VRE penetration but does not integrate storage integration further than the base case due to reaching the upper limit of the storage capacity set in the planning experiments.
Pumped hydro storage was found to increase the resilience of the modelled energy systems to climate-driven seasonal uncertainties and prices due to fossil fuel and carbon price uncertainties by making them less dependent on fossil fuels, decreasing vulnerability for potential emission penalties, and seasonal capacity fluctuations. The introduction of PHS was also found not to increase overall system costs, making it, combined with the stable levelised cost of storage and high maturity, a prime candidate for large-scale energy storage in Ethiopia.
Long-term investment planning and system operations for energy, depend on and compete with other sectors for, the availability of water (for hydropower and cooling thermal plants) and land resources (e.g. for biofuel production and arability). The efficient exploitation of land, energy and water resources and their synergised use for economic development therefore require an multidimensional integrated optimisation approach co-created with stakeholders in dialogue. This starts with planning followed by prioritised investments based on local, national and regional needs in the energy, agricultural and water sectors. This is mostly lacking in SSA at the moment. We gathered a selected group of experts in Accra, Ghana in November 2022 with a broad mix of experiences and expertise in the energy, water and agricultural sectors, who shared deeper insights and values of the need for integrated WEF planning to begin tackling challenges and opportunities identified in the Volta Basin in West Africa (starting with Ghana) and the Tana basin in Kenya. The main challenge identified was the disjointed planning of WEF infrastructures due to different financing mechanisms and siloed sectoral thinking; and participants raised emerging opportunities for planning infrastructure through transnational and regional cooperation as well as the need to build on existing and new initiatives devoid of entrenched political goals.
In this contribution, we will present some of the main findings from the meeting in Accra and share knowledge on how transparent WEF modelling can be contextualised for local operational relevance, and through co-creation, how interactive engagement tools can be used for planning, policy- and decision-making. ...
Long-term investment planning and system operations for energy, depend on and compete with other sectors for, the availability of water (for hydropower and cooling thermal plants) and land resources (e.g. for biofuel production and arability). The efficient exploitation of land, energy and water resources and their synergised use for economic development therefore require an multidimensional integrated optimisation approach co-created with stakeholders in dialogue. This starts with planning followed by prioritised investments based on local, national and regional needs in the energy, agricultural and water sectors. This is mostly lacking in SSA at the moment. We gathered a selected group of experts in Accra, Ghana in November 2022 with a broad mix of experiences and expertise in the energy, water and agricultural sectors, who shared deeper insights and values of the need for integrated WEF planning to begin tackling challenges and opportunities identified in the Volta Basin in West Africa (starting with Ghana) and the Tana basin in Kenya. The main challenge identified was the disjointed planning of WEF infrastructures due to different financing mechanisms and siloed sectoral thinking; and participants raised emerging opportunities for planning infrastructure through transnational and regional cooperation as well as the need to build on existing and new initiatives devoid of entrenched political goals.
In this contribution, we will present some of the main findings from the meeting in Accra and share knowledge on how transparent WEF modelling can be contextualised for local operational relevance, and through co-creation, how interactive engagement tools can be used for planning, policy- and decision-making.
Plastic pollution in rivers threatens ecosystems, increases flood risk due to its accumulations at hydraulic structures and its final emissions into the ocean threaten aquatic life, especially and probably most in coastal urbanized areas. Previous work suggests that plastic pollution in these urban rivers is influenced by hydrometeorological and anthropogenic factors. However, the transport dynamics of the plastics in such rivers are non-linear and complex and remain largely unresolved. Here, we show that tidal dynamics can be the main driver of plastic transport closest to the river mouth. Outside the tidal zone, rainfall and river discharge were identified to be more important drivers. We monitored plastic transport in the Odaw river, Ghana during the dry season. The Odaw drains the densely populated city of Accra and discharges into the Gulf of Guinea. Data were collected between March and May 2021 (dry season), using visual counting at four bridges along the river, of which two were located within the tidal zone. We explored the correlations between river plastic transport, and rainfall, tidal dynamics, and river discharge. Finally, we estimated the total plastic mass transport by using item-to-mass conversion data from previously published literature. We observed a peak in plastic transport at the upstream bridge within the tidal zone after an increase in rainfall (7.3 times larger). We found a gradient of the hydrometeorological factors driving plastic transport. Closer to the river mouth, tidal dynamics were more strongly correlated with plastic transport than upstream. The daily mass transport was estimated to be between 1.4–3.8 × 102 kg/d, which is lower than previous model estimates. These results add to the evidence of inconsistent correlations between plastic transport and hydrometeorological variables. Long-term monitoring data is required to further investigate this. The results also support the hypothesis that tidal dynamics are a crucial factor in controlling the emissions of plastics from rivers into the ocean. The findings provide a baseline for the Odaw river during the dry season and allow for comparison with the wet season. The approach adopted here also serves as a blueprint for similar urban river systems, regionally and globally.
In 2009, the International Soil Moisture Network (ISMN) was initiated as a community effort, funded by the European Space Agency, to serve as a centralised data hosting facility for globally available in situ soil moisture measurements . The ISMN brings together in situ soil moisture measurements collected and freely shared by a multitude of organisations, harmonises them in terms of units and sampling rates, applies advanced quality control, and stores them in a database. Users can freely retrieve the data from this database through an online web portal (https://ismn.earth/en/, last access: 28 October 2021). Meanwhile, the ISMN has evolved into the primary in situ soil moisture reference database worldwide, as evidenced by more than 3000 active users and over 1000 scientific publications referencing the data sets provided by the network. As of July 2021, the ISMN now contains the data of 71 networks and 2842 stations located all over the globe, with a time period spanning from 1952 to the present. The number of networks and stations covered by the ISMN is still growing, and approximately 70 % of the data sets contained in the database continue to be updated on a regular or irregular basis. The main scope of this paper is to inform readers about the evolution of the ISMN over the past decade, including a description of network and data set updates and quality control procedures. A comprehensive review of the existing literature making use of ISMN data is also provided in order to identify current limitations in functionality and data usage and to shape priorities for the next decade of operations of this unique community-based data repository.
The first five years of the Trans-African Hydro-Meteorological observatory (TAHMO)
From nice idea to a network of 500+ stations (Invited)
The effects of small water surfaces on turbulent flow in the atmospheric boundary layer
URANS approach implemented in OpenFOAM
TWIGA: Sensors for geo-services in Africa
Early results, perspectives, and an invitation
Atmospheric stability conditions over the water surface can affect the evaporative and convective heat fluxes from the water surface. Atmospheric instability occurred 72.5% of the time and resulted in 44.7 and 89.2% increases in the average and maximum estimated evaporation, respectively, when compared to the neutral condition for a small shallow lake (Binaba) in Ghana. The proposed approach is based on the bulk-aerodynamic transfer method and the Monin-Obukhov similarity theory (MOST) using standard meteorological parameters measured over the surrounding land. For water surface temperature, a crucial parameter in heat flux estimation from water surfaces, an applicable method is proposed. This method was used to compute heat fluxes and compare them with observed heat fluxes. The heat flux model was validated using sensible heat fluxes measured with a 3-D sonic anemometer. The results show that an unstable atmospheric condition has a significant effect in enhancing evaporation alongside the sensible heat flux from water surfaces.
Understanding of hydroclimatic processes in Africa has been hindered by the lack of in situ precipitation measurements. Satellite-based observations, in particular, the TRMM Multisatellite Precipitation Analysis (TMPA) have been pivotal to filling this void. The recently released Integrated Multisatellite Retrievals for GPM (IMERG) project aims to continue the legacy of its predecessor, TMPA, and provide higher-resolution data. Here, IMERG-V04A precipitation data are validated using in situ observations from the Trans-African Hydro-Meteorological Observatory (TAHMO) project. Various evaluation measures are examined over a select number of stations in West and East Africa. In addition, continent-wide comparisons are made between IMERG and TMPA. The results show that the performance of the satellite-based products varies by season, region, and the evaluation statistics. The precipitation diurnal cycle is relatively better captured by IMERG than TMPA. Both products exhibit a better agreement with gauge data in East Africa and humid West Africa than in the southern Sahel. However, a clear advantage for IMERG is not apparent in detecting the annual cycle. Although all gridded products used here reasonably capture the annual cycle, some differences are evident during the short rains in East Africa. Direct comparison between IMERG and TMPA over the entire continent reveals that the similarity between the two products is also regionally heterogeneous. Except for Zimbabwe and Madagascar, where both satellite-based observations present a good agreement, the two products generally have their largest differences over mountainous regions. IMERG seems to have achieved a reduction in the positive bias evident in TMPA over Lake Victoria.
Investigation of temperature dynamics in small and shallow reservoirs, case study
Lake Binaba, Upper East Region of Ghana
An unsteady fully three-dimensional model of Lake Binaba (a shallow small reservoir) in semi-arid Upper East Region of Ghana has been developed to simulate its temperature dynamics. The model developed is built on the Reynolds Averaged Navier-Stokes (RANS) equations, utilizing the Boussinesq approach. As the results of the model are significantly affected by the physical conditions on the boundaries, allocating appropriate boundary conditions, particularly over a water surface, is essential in simulating the lake's thermal structure. The thermal effects of incoming short-wave radiation implemented as a heat source term in the temperature equation, while the heat fluxes at the free water surface, which depend on wind speed, air temperature, and atmospheric stability conditions are considered as temperature boundary condition. The model equations were solved using OpenFOAM CFD toolbox. As the flow is completely turbulent, which is affected by the complex boundary conditions, a new heat transfer solver and turbulence model were developed to investigate the spatial and temporal distribution of temperature in small and shallow inland water bodies using improved time-dependent boundary conditions. The computed temperature values were compared with four days of observed field data. Simulated and observed temperature profiles show reasonable agreement where the root mean square error (RMSE) over the simulation period ranges from 0.11 to 0.44 °C in temporal temperature profiles with an average value of 0.33 °C. Results indicate that the model is able to simulate the flow variables and the temperature distribution in small inland water bodies with complex bathymetry.