The effect of the carbon-to-nitrogen (C/N) ratio in the influent on the nitrous oxide (N2O) emission from a University of Cape Town Membrane BioReactor pilot plant was investigated. The membrane was located in a separate tank to single out the production of N2O due to the biological processes from N2O stripping as a result of the extra aeration needed for the mitigation of membrane fouling. The experimental campaign was divided into two phases, each characterized by a different C/N ratio (namely, 10 and 5 mgCOD/mgTN, Phase I and Phase II, respectively). The decrease of the C/N ratio promoted the increase of N2O emissions in both gaseous and dissolved phases, mainly due to a decreased nitrification/denitrification capacity of the system. The highest N2O concentration in the dissolved phase was found in the permeate. This result suggests that the dissolved N2O in the permeate stream discharged from a MBR cannot be neglected. The total N2O emission was approximately of 0.01% and 0.1% of the total influent nitrogen load for the Phase I and Phase II, respectively. The findings suggest that the C/N ratio represents an indirect cause of N2O emission; the low C/N value (Phase II) led to the increase of pH and free ammonia causing a stress effect on the growth of nitrifying species increasing the N2O emission.@en

This study aimed at evaluating the nitrous oxide (N2O) emissions from membrane bioreactors (MBRs) for wastewater treatment. The study investigated the N2O emissions considering multiple influential factors over a two-year period: (i) different MBR based process configurations; (ii) wastewater composition (municipal or industrial); (iii) operational conditions (i.e. sludge retention time, carbon-to-nitrogen ratio, C/N, hydraulic retention time); (iv) membrane modules. Among the overall analysed configurations, the highest N2O emission occurred from the aerated reactors. The treatment of industrial wastewater, contaminated with salt and hydrocarbons, provided the highest N2O emission factor (EF): 16% of the influent nitrogen for the denitrification/nitrification-MBR plant. The lowest N2O emission (EF = 0.5% of the influent nitrogen) was obtained in the biological phosphorus removal-moving bed-MBR plant likely due to an improvement in biological performances exerted by the co-presence of both suspended and attached biomass. The influent C/N ratio has been identified as a key factor affecting the N2O production. Indeed, a decrease of the C/N ratio (from 10 to 2) promoted the increase of N2O emissions in both gaseous and dissolved phases, mainly related to a decreased efficiency of the denitrification processes.@en

Nowadays, it is widely accepted that wastewater treatment plants (WWTPs) are significant sources of greenhouse gas (GHG) emission, contributing to the anthropogenic sources. Among the GHG emitted from WWTPs, nitrous oxide (N2O) has been identified of having the major interest/concern, since its high global warming potential (GWP), is 298 times higher than that of CO2 and also to its capability to react with stratospheric ozone causing the layer depletion. Up to now, most of the experimental investigations have been carried out on conventional activated sludge (CAS) processes. The knowledge of N2O emission from advanced technologies such membrane bioreactors (MBRs) is still very limited. The present paper is aimed at providing a picture of the GHG emissions from MBR systems. In particular, data of N2O acquired from pilot plant systems monitoring are here presented. The key aim of the study was to highlight the effect of wastewater features and operational conditions on N2O production/emission from MBRs.@en

In this study a University of Cape Town (UCT) Integrated Fixed Film Activated Sludge (IFAS) Membrane BioReactor (MBR) wastewater treatment plant was monitored in terms of nitrous oxide (N2O) emissions. The short term effect on the N2O emission due to the influent carbon-to-nitrogen (C/N) ratio variation (C/N ratios of 2, 5 and 10 gCOD/gN) was evaluated. Since in a previous study, the effect of the C/N ratio was studied in the same system without biofilm (UCT-MBR configuration) the main aim here was to investigate the role of biofilms on N2O emissions. Under all the investigated C/N ratios, the N2O fluxes and the average emission factors were lower than that of previous studies with no biofilm presence. The total average N2O emission was 0.5% of the influent nitrogen with biofilm (IFAS system) and 3.5% without biofilm. This result emphasizes the potential role of the biofilms in attenuating the N2O emissions especially in the case of stress conditions (i.e., low C/N influent ratios). An increase of N2O flux from the anoxic reactor (till 28 mgN2O m-2h-1) occurred at the lowest influent C/N tested (2 gCOD/gN - phase III). At C/N equal to 2 gCOD/gN the anoxic reactor was the main source of N2O, contributing 45% of all produced N2O. This result was attributed to an incomplete denitrification caused by a lack of organic carbon and a slight increase of dissolved oxygen concentration.@en