Macro-, meso-, micro-pore systems combined with clay content are critical for fluid flow behavior in tight sandstone formations. This study investigates the impact of clay mineralogy on pore systems in tight rocks. Three outcrop samples were selected based on their comparative petrophysical parameters (Bandera, Kentucky, and Scioto). Our experiments carried out to study the impact of clay content on micro-pore systems in tight sandstone reservoirs involve the following techniques: Routine core analysis (RCA), to estimate the main petrophysical parameters such as porosity and permeability, X-ray diffraction (XRD), and scanning electron microscopy (SEM) to assess mineralogy and elemental composition, Mercury Injection Capillary Pressure (MICP), Nuclear Magnetic Resonance (NMR), and Micro-Computed Tomography (Micro-CT) to analyze pore size distributions. Clay structure results show the presence of booklets of kaolinite and platelets to filamentous shapes of illite. The Scioto sample exhibits a micro-pore system with an average pore body size of 12.6±0.6 μm and an average pore throat size of 0.25±0.19 μm. In Bandera and Kentucky samples illite shows pore-bridging clay filling with an average mineral size of around 0.25±0.03 μm, which reduces the micro-pore throat system sizes. In addition, pore-filling kaolinite minerals with a diameter of 5.1±0.21 μm, also reduce the micro-pore body sizes. This study qualifies and quantifies the relationship of clay content with primary petrophysical properties of three tight sandstones. The results help to advance procedures for planning oil recovery and CO2 sequestration in tight sandstone reservoirs.@en

A full petrographic and petrophysical characterization of tight sandstones has been conducted as part of ongoing study of Carbon Dioxide Enhanced Oil and Gas Recovery (CO2-EOR/EGR) and CO2sequestration. The main purpose of this study is to give novel perception into the interplay of the rock characteristics and fluid flow in tight formations, which are candidates for EOR/EGR processes (macroscopic sweep vs. microscopic displacement efficiency). To achieve this, several experimental techniques, including routine core analysis, X-ray diffraction (XRD), X-ray fluorescence (XRF), thin sections petrography, Scanning Electron Microscopy (SEM) and capillarity/pore size distributions by using Mercury Injection Capillary Pressure (MICP), Nuclear Magnetic Resonance (NMR), and Micro-Computed Tomography (Micro-CT), were conducted. Three tight sandstone rock samples (Bandera, Kentucky, and Scioto) were used in this work and particular attention was paid to the impact of clay content on rock's pore system and other petrophysical characteristics and hence fluids flow during production process. Results indicate that the presence of fibrous illite clay acting as pore bridging in Bandera and Kentucky samples have blocked the overall micro-pore system causing a significant reduction in the micro-pore throat system to 36% in Bandera sand and 50.9% in Kentucky sample. On the other hand, absence of fibrous illite and the presence of illite platelets in the Scioto sandstone led to a clear preservation of the sample's micro-pore throat attributing to a total of 59.1% of the total pore throat system. A new dimensionless number (dimensionless micro-pore throat modality) was established, defined as the ratio of micro-to macro-pore sizes. This shows that Scioto has the highest value of 1.44 implying that both macro- and micro-pore systems contribute to flow. Therefore, the mitigation of oil bypass from smaller pores should be a key criterion in selecting the proper recovery methods. Results show the effect of clay mineralogy on pore system considering a part of the physical and spatial properties the pore/grain framework of the tight sandstones.@en

The wood of the Cembran pine (Pinus cembra L.), also known as Swiss pine, Arolla pine or Stone pine, has a prominent and long-lasting odor which has been reported to relieve stress in humans. However, the odorants responsible for this are unknown and it is also unclear whether the odor profile depends on the origin of the trees, namely different geographical regions and pedoclimatic conditions. Therefore, in this study human sensory analyses together with isolation and analysis of the target odorants via solvent-assisted flavor evaporation were performed. Afterwards, comparative odor extract dilution analysis (cOEDA) was applied to investigate the odorous constituents of pinewood samples from forests in Austria and Italy. Specific odorants were thereby identified using one-dimensional and two-dimensional gas chromatography-mass spectrometry/olfactometry using two capillary columns with different polarities (DB-5 and DB-FFAP). In total, 103 odorants were detected with successful identification of 98 of these substances. The identified odorants were predominately monoterpenes and sesquiterpenes as well as organic acids. Several compounds including germacrene D, thymol, carvacrol, rotundone, β-caryophyllene, α-humulene, cinnamaldehyde, and ethyl cinnamate are reported here for the first time as odorous constituents of pinewood. Principal component analysis of the data obtained from sensory evaluation and cOEDA indicated that terpenes and sesquiterpenes were correlated with higher hedonic rates for the wood samples. Moreover, a Mantel test between the geographical distances of the trees and their sensory and cOEDA values demonstrated that the origin of the trees had a significant impact on the sensory characteristics of the wood, in agreement with the differences in the relative proportions of different volatile components. As such, the odor of Cembran pinewood is prone to variation but, yet, unique.@en

Oak wood contains aroma-active compounds that contribute significantly to the chemical structure, olfactory and gustatory qualities of alcoholic beverages and vinegars as by-products that have been either fermented and/or aged in oak barrels. The chemical composition of cooperage oak is highly variable, depending on the degree of toasting and natural seasoning. However, it is unclear whether the odor of oak varies according to different geographical regions and pedoclimatic conditions. Especially in view of the actual challenges in forestry in relation to climate change, the present study aimed at elucidating the odorous constituents of nine natural oak samples from Germany, Austria and Hungary with respect to these influencing parameters. The odor profiles of the oaks were compared, the potent odorants were determined, and selected odorants were quantified using stable isotope dilution assays (SIDA). The majority of the identified odorants in all samples were fatty acid degradation products, followed by a series of odorants with terpenoic structure and others resulting from the degradation of lignin. Several different odorants including 2-propenoic acid and cinnamaldehyde are reported here for the first time in oaks from different growth regions. Odor activity values (OAVs), calculated based on odor thresholds (OTs) in water, revealed hexanal, (E)-2-nonenal, (Z)-3-hexenal, eugenol, vanillin, and whiskey lactone as potent odorants for the oak odor. Principal component analysis of the data obtained from sensory evaluation, comparative aroma extract dilution analysis (cAEDA) and their corresponding quantified odorants showed that the highest separation rate was obtained for Hungarian oak, whereas Austrian and Bavarian oak samples were more similar. Recombination experiments by mixing the dominant odorants in their naturally occurring concentrations revealed a good agreement of the smell properties of the model mixture with the smell of the respective original sample. These findings aim at evaluating and establishing a better understanding of the distinctive smell of oak wood and demonstrated the prospects of new oak sources.@en