The increase of inter-particle cohesive force greatly changes the fluidization dynamics, finally leading to the partial or complete failure of fluidization. However, few studies concern such transition process. This paper investigates the fluidization dynamics of Geldart B particles with a wide-range of cohesive force by analyzing the in-bed pressure fluctuation signals. Combining the bubble information reported in Part I, the local and global fluidization dynamics under different cohesive forces were discussed. The results show that bulk bubble dynamics is weaken with the presence of inter-particle cohesive force. As the force increases, fluidization changes from multi-bubbling regime to single-bubble regime and the factor governing the pressure fluctuation changes from bubble formation to bubble eruption. When the cohesive force is strong, slugging appears near the bed surface, then gradually extends toward the bottom bed by capturing freely fluidizing particles, and finally develops into the whole-bed slugging. At this time, regular fluidization turns into an alternative process between whole-bed slugging and regular status, corresponding to two distinct peaks in power spectral density of pressure signals at 0.1 Hz and 1 Hz respectively. The size of gas slug decreases with the elevation of measurement height. Basically, any operations that promote bubble growth will also facilitate the appearance of whole-bed slugging under strong cohesive force. Reducing the static bed height is a preferable approach to weaken, or even avoid the defluidization of whole-bed slugging, without changing other operational parameters.@en

Due to the presence of inter-particle cohesive force, cohesive particles reveal totally different fluidization behaviors as compared to the non-cohesive system. This paper studies the fluidization dynamics of Geldart B particles with varying thermal-induced cohesive forces. Multi-source X-ray tomography was applied to reconstruct 3D temporal images of bubbles, based on which, various bubble properties were extracted. The results show that increasing cohesive force will decrease bubble number while increase bubble size, implying that the presence of cohesive force facilitates bubble coalescence. By examining the bubble size distribution, cohesive force is found to have no effect on the number of median bubbles but greatly influence small and large bubbles. When the cohesive force is strong, the bubbles grow to a considerable size similar with bed dimension, giving rise to slugging near bed surface. With the action of inter-particle cohesive force, particle slug gradually grows by capturing other freely fluidizing particles, finally inducing “whole-bed” slugging. The particle slug may rupture in the rising process, and the bed turns back to normal fluidization. In comparison to normal bubbles, the gas slug has much larger size but far smaller frequency. The rise velocity of gas slug is also very low due to the particle-wall friction and gas-solid momentum dissipation. Therefore, the averaged values of bubble properties dramatically changed as bed temperature exceeds 35 °C. When the temperature attains 45 °C, the cohesive force is so strong that the fluidization completely fails in terms of stable whole-bed slugging.@en

Bubbles and slugs coexist in a fluidized bed with strong inter-particle forces. However, the effects bubbles and slugs impose over fluidizing stability, and chemical reaction efficiency are different. The present work distinguished bubbles and slugs with the aid of X-ray tomography, and the evolution of their properties with varying inter-particle force in a fluidized bed were studied. The results show that the gas-holding capacity of the emulsion phase improves as inter-particle forces initially increase. In this process, the bubble frequency decreases noticeably, and the bubble size slightly increases. Bubbles rise slower than theoretically predicted because inter-particle force reduces the particle flow. The frequency and the size of slugs increase with inter-particle forces. As forces initially increases, the slug size increases with measurement height. An opposite trend is observed when inter-particle forces continues to strengthen. Near the gas distributor, the slug rising velocity is independent of size. In contrast, large slugs have a higher velocity than small slugs near the bed surface. Finally, three slugging patterns are distinguished, and the influence they impose on particle flow is analyzed.@en