There has been a long-standing interest in controlling and instrumenting the human body. Whether to restore lost function with neural prosthetics, monitor blood glucose levels, or augment human capabilities, there are countless opportunities for sensors inside ( e.g., ingestible, injectable, and implantable) and outside ( e.g., wearable) the body. However, many challenges exist when instrumenting the body. First, many use cases ( e.g., implanted sensors) require long-term recording to capture anomalous behavior—sometimes with limited accessibility—necessitating ultralow power consumption. Second, the power reduction challenge is further exacerbated by size constraints, which limit battery capacity or harvestable energy levels. Third, the signals of interest are often low bandwidth (kHz) and small in amplitude (µV to mV); thus, low-noise front ends are needed. Addressing these challenges has led to a large body of work on the design of highly power-efficient, low-noise amplifiers for biomedical integrated circuits.@en

Complex concentrated alloys (CCAs) with a face-centered-cubic (FCC) structure exhibit remarkable mechanical properties, introducing the expansion of compositional space in alloy design for structural materials. The formation of a single solid-solution phase is enabled by configuring various 3d-transition elements, while doping other elements even of a small portion generally leads to the formation of brittle intermetallic compounds. Herein, we demonstrate through a systematic investigation of single FCC (CoNi)_100-xMo_x alloys that a wide range of refractory element Mo can simultaneously improve the strength and ductility while sustaining the solid-solution structure. The addition of Mo with a larger atomic size than those of 3d-transition elements introduces severe lattice distortion in the FCC lattice and causes grain-boundary segregation enriched by Mo atoms. In addition, increasing Mo content effectively reduces the stacking fault energy (SFE). The increased lattice distortion with Mo content enhances the solid-solution strengthening of the alloys. Besides, along with reduced SFE and stabilization of the dislocation emission site by grain-boundary segregation, this elevated solid-solution strengthening increases grain-boundary strengthening, reaching a yield strength of ∼1 GPa. Moreover, the reduction of SFE with increasing Mo results in the transition of dislocation substructures and the refinement of deformation twins, allowing for enhanced strain-hardening capability and thus ∼1.3 GPa tensile strength and ∼50% ductility. Such compositive and synergetic effects of refractory element Mo enable the CCAs with a single FCC solid solution to overcome the strength and ductility trade-off.

@en

Precipitation strengthening has been the basis of physical metallurgy since more than 100 years owing to its excellent strengthening effects. This approach generally employs coherent and nano-sized precipitates, as incoherent precipitates energetically become coarse due to their incompatibility with matrix and provide a negligible strengthening effect or even cause brittleness. Here we propose a shear band-driven dispersion of nano-sized and semicoherent precipitates, which show significant strengthening effects. We add aluminum to a model CoNiV medium-entropy alloy with a face-centered cubic structure to form the L2₁ Heusler phase with an ordered body-centered cubic structure, as predicted by ab initio calculations. Micro-shear bands act as heterogeneous nucleation sites and generate finely dispersed intragranular precipitates with a semicoherent interface, which leads to a remarkable strength-ductility balance. This work suggests that the structurally dissimilar precipitates, which are generally avoided in conventional alloys, can be a useful design concept in developing high-strength ductile structural materials.

@en