Pressure on the coastline is escalating due to the impacts of climate change, this is leading to a rise in sea-levels and intensifying storminess. Consequently, many regions of the coast are at increased risk of erosion and flooding. Therefore coastal protection schemes will increase in cost and scale. In response there is a growing use of nature-based coastal protection which aim to be sustainable, effective and adaptable. An example of a nature-based solution is a dynamic cobble berm revetment: a berm constructed from cobble and other gravel sediments at the high tide wave runup limit. These structures limit wave excursion protecting the hinterland from inundation, stabilise the upper beach and adapt to changes in water level. Recent experiments and field applications have shown the suitability of these structures for coastal protection, however many of the processes and design considerations are poorly understood. This study directly compares two prototype scale laboratory experiments which tested dynamic cobble berm revetments constructed with approximately the same geometry but differing gravel characteristics; well-sorted rounded gravel (DynaRev1) and poorly-sorted angular gravel (DynaRev2). In both cases the structures were tested using identical wave forcing including incrementally increasing water level and erosive wave conditions. The results presented in this paper demonstrate that both designs responded to changing water level and wave conditions by approaching a dynamically stable state, where individual gravel is mobilised under wave action but the geometry remains approximately constant. Further, both structures acted to reduce swash excursions compared to a pure sand beach. However, their morphological behaviour is response to wave action varied considerably. Once overtopping of the designed crest occurred, the poorly-sorted revetment developed a peaked crest which grew in elevation as the water level or wave height increased, further limited overtopping. By comparison, the well-sorted revetment was characterised by a larger volume of submerged gravel and a lower elevation flat crest which responded less well to changes in conditions. This occurred due to two processes: (1) for the poorly-sorted case, gravel sorting processes moved small to medium gravel material (D₅₀<70mm) to the crest and (2) the angular nature of the poorly-sorted gravel material promoted increased interlocking. Both of these processes led to a gravel matrix that is more resistant to wave action and gravitational effects. Both revetments experienced some sinking due to sand erosion beneath the front slope. The rate of sinking for the well-sorted case was larger and continued throughout due to the large pore spaces within the gravel matrix. For the poorly sorted revetment in DynaRev2, sand erosion ceased after approximately 28 h due to the development of a filter layer of small gravel at the sand-gravel interface reducing porosity at this location, hence a larger volume of sand was preserved beneath the structure. Both designs present a low-cost and effective solution for protecting sandy coastlines but from an engineering viewpoint it appears better to avoid well-sorted gravel material and greater gravel angularity has been seen to increase crest stability.

Vegetation-wave interactions are critical in determining the capacity of coastal salt marshes to reduce wave energy (wave dissipation), enhance sedimentation and protect the shoreline from erosion. While vegetation-induced wave dissipation is increasingly recognized in low wave energy environments, little is known about: (i) the effect of vegetation on wave dissipation during storms when wave heights and water levels are highest; and (ii) the ability of different plant species to dissipate waves and to maintain their integrity under storm surge conditions. Experiments undertaken in one of the world's largest wave flumes allowed, for the first time, the study of vegetation-wave interactions at near-field scale, under wave heights ranging from 0.1–0.9 m (corresponding to orbital velocities of 2–91 cm s⁻¹) and water depths up to 2 m, in canopies of two typical NW European salt marsh grasses: Puccinellia maritima (Puccinellia) and Elymus athericus (Elymus). Results indicate that plant flexibility and height, as well as wave conditions and water depth, play an important role in determining how salt marsh vegetation interacts with waves. Under medium conditions (orbital velocity 42–63 cm s⁻¹), the effect of Puccinellia and Elymus on wave orbital velocities varied with water depth and wave period. Under high water levels (2 m) and long wave periods (4.1 s), within the flexible, low-growing Puccinellia canopy orbital velocity was reduced by 35% while in the more rigid, tall Elymus canopy deflection and folding of stems occurred and no significant effect on orbital velocity was found. Under low water levels (1 m) and short wave periods (2.9 s) by contrast, Elymus reduced near-bed velocity more than Puccinellia. Under high orbital velocities (≥74 cm s⁻¹), flattening of the canopy and an increase of orbital velocity was observed for both Puccinellia and Elymus. Stem folding and breakage in Elymus at a threshold orbital velocity ≥ 42 cm s⁻¹ coincided with a levelling-off in the marsh wave dissipation capacity, while Puccinellia survived even extreme wave forces without physical damage. These findings suggest a species-specific control of wave dissipation by salt marshes which can potentially inform predictions of the wave dissipation capacity of marshes and their resilience to storm surge conditions.

A full-scale controlled experiment was conducted on an excavated and re-assembled coastal wetland surface, typical of floristically diverse northwest European saltmarsh. The experiment was undertaken with true-to-scale water depths and waves in a large wave flume, in order to assess the impact of storm surge conditions on marsh surface soils, initially with three different plant species and then when this marsh canopy had been mowed. The data presented suggests a high bio-geomorphological resilience of salt marshes to vertical sediment removal, with less than 0.6cm average vertical lowering in response to a sequence of simulated storm surge conditions. Both organic matter content and plant species exerted an important influence on both the variability and degree of soil surface stability, with surfaces covered by a flattened canopy of the salt marsh grass Puccinellia experiencing a lower and less variable elevation loss than those characterized by Elymus or Atriplex that exhibited considerable physical damage through stem folding and breakage.

Moving water exerts drag forces on vegetation. The susceptibility of vegetation to bending and breakage determines its flow resistance, and chances of survival, under hydrodynamic loading. To evaluate the role of individual vegetation parameters in this water-vegetation interaction, we conducted drag force measurements under a wide range of wave loadings in a large wave flume. Artificial vegetation elements were used to manipulate stiffness, frontal area in still water and material volume as a proxy for biomass. The aim was to compare: (i) identical volume but different still frontal area, (ii) identical stiffness but different still frontal area, and (iii) identical still frontal area but different volume. Comparison of mimic arrangements showed that stiffness and the dynamic frontal area (i.e., frontal area resulting from bending which depends on stiffness and hydrodynamic forcing) determine drag forces. Only at low orbital-flow velocities did the still frontal area dominate the force-velocity relationship and it is hypothesised that no mimic bending took place under these conditions. Mimic arrangements with identical stiffness but different overall material volume and still frontal area showed that forces do not increase linearly with increasing material volume and it is proposed that short distances between mimics cause their interaction and result in additional drag forces. A model, based on effective leaf length and characteristic plant width developed for unidirectional flow, performed well for the force time series under both regular and irregular waves. However, its uncertainty increased with increasing interaction of neighbouring mimics.

Coastal communities around the world face an increasing risk from flooding as a result of rising sea level, increasing storminess and land subsidence¹². Salt marshes can act as natural buffer zones, providing protection from waves during storms³⁷. However, the effectiveness of marshes in protecting the coastline during extreme events when water levels are at a maximum and waves are highest is poorly understood^8,9. Here we experimentally assess wave dissipation under storm surge conditions in a 300-metre-long wave flume tank that contains a transplanted section of natural salt marsh. We find that the presence of marsh vegetation causes considerable wave attenuation, even when water levels and waves are highest. From a comparison with experiments without vegetation, we estimate that up to 60% of observed wave reduction is attributed to vegetation. We also find that although waves progressively flatten and break vegetation stems and thereby reduce dissipation, the marsh substrate remained stable and resistant to surface erosion under all conditions. The effectiveness of storm wave dissipation and the resilience of tidal marshes even at extreme conditions suggest that salt marsh ecosystems can be a valuable component of coastal protection schemes.