Recent advancements in laser and imaging systems, as well as in computational processing capabilities, have made quantitative optical imaging, which is often combined with laser illumination, highly adaptable, robust and reliable. Laser-based diagnostic techniques, such as planar laser-induced fluorescence (PLIF), offer the possibility of simultaneous spatiotemporally resolved measurements of temperature fields in the liquid phase at boiling conditions. In this paper, we examine the applicability of two-colour PLIF (2cPLIF), where the ratio between individual fluorescent emissions from uniformly dispersed dyes is used to take temperature measurements in the liquid phase in the presence of moving vapour-liquid interfaces typical of boiling flow. The implementation of 2cPLIF necessitates uniformity in the concentration of different dyes across the flow field. However, in the case of a multiphase flow such as boiling, thermophoresis can lead to inhomogeneous dye distributions. To overcome this challenge, a single-dye multispectral planar laser-induced fluorescence (SDMS-PLIF) method has been developed, which employs fluorescent emissions in different spectral bands of the same dye (Nile Red). The spectral characteristics of Nile Red were measured using a spectrometer to identify its temperature-sensitive bands over a wide range of dye concentrations, from 0.3 to 30 mg/L. Following this, we demonstrate the measurement capabilities of SDMS-PLIF thermography as applied to a boiling flow in a miniaturised vertical square channel, gaining insight into the thermohydrodynamic interactions between vapour bubbles and a heated wall.

We report on the experimental study of turbulent transport in the near field of swirling jets at Re = 5000 by using simultaneously the stereoscopic particle image velocimetry and planar laser-induced fluorescence methods. The present focus is on the analysis of terms of the mean (axial) momentum and scalar (mass) transport equations, estimated from the mean velocity and concentration, the Reynolds stress and turbulent flux components, measured in the central axial plane of the jets. A proper orthogonal decomposition has also been applied to the velocity data sets to analyse contribution of the coherent velocity and scalar fluctuations to the turbulent momentum and mass fluxes for different swirl rates.

We report on a study of the impact of coherent helical vortex structures on the shape of the reaction zone and heat release in swirling methane/air flames in regimes with a vortex breakdown. Three kinds of atmospheric flames are considered, viz., fuel-lean and fuel-rich premixed flames and a partially premixed fuel-rich lifted flame. Based on the measurements of the velocity fields by a stereo PIV in combination with the OH PLIF and HCHO PLIF, the impact of the coherent flow structures on large-scale corrugations of the reaction zone is evaluated. Helical vortex structures, detected in both the non-reacting and reacting high-swirl flows by using proper orthogonal decomposition, are found to promote combustion both in the lean premixed and fuel-rich partially premixed flames. In the first case, based on the phase-averaged intensity of the HCHO×OH signal and the location of the helical vortex structure in the inner mixing layer, it is concluded that the vortex locally increases the heat release rate by enlarging the flame front and enhancing the mass exchange between the combustion products inside the recirculation zone and the fresh gases. The events of the local flame extinctions are detected in the instantaneous PLIF snapshots for the lean mixture, but they do not cause extinction of the entire flame or a blow-off. In case of the lifted flame, the outer helical vortex structure promotes combustion by locally intensifying the mass exchange between the fuel-rich jet with the surrounding air.