Second flexural and torsional modes of vibration in suspended microfluidic resonator for liquid density measurements

Journal article (2020)

Authors

P. Belardinelli Dynamics of Micro and Nano Systems - Mechanical, Maritime and Materials Engineering
Savio D Souza Student
E.J. Verlinden Computational Design and Mechanics - Mechanical, Maritime and Materials Engineering , Micro and Nano Engineering - Mechanical, Maritime and Materials Engineering
J. Wei EKL Processing - EEMCS
U. Staufer Micro and Nano Engineering - Mechanical, Maritime and Materials Engineering
F. Alijani Dynamics of Micro and Nano Systems - Mechanical, Maritime and Materials Engineering
M.K. Ghatkesar Micro and Nano Engineering - Mechanical, Maritime and Materials Engineering
Research Group
Micro and Nano Engineering (Mechanical, Maritime and Materials Engineering) (TU Delft)
Copyright: © 2020 P. Belardinelli, Savio D Souza, E.J. Verlinden, J. Wei, U. Staufer, F. Alijani, M.K. Ghatkesar
DOI
help_outline
https://doi.org/10.1088/1361-6439/ab772c
Quality factor Resonance frequency Suspended microchannel resonator Micro uidic cantilever Hollow microcantilever Density measurement
More Info
expand_more

Published Date

2020

Language

English

Faculty

Mechanical, Maritime and Materials Engineering

Department

Precision and Microsystems Engineering

Research Group

Micro and Nano Engineering

Abstract

Suspended microfluidic resonators enable detection of fluid density and viscosity with high sensitivity. Here, a two-legged suspended microchannel resonator that probes pico-litres of liquid is presented. The higher resonant modes (flexural and torsional) were explored for increased sensitivity and resolution. Unlike other reported microchannel resonators, this device showed an increase in the quality factor with resonant frequency value. The performance of the resonator was tested by filling the channel with three liquids, one at a time, over a density range of 779 - 1110 Kg/m^3 and a viscosity range of 0.89 - 16.2 mPa.s. The highest resolution obtained was 0.011% change in density. Measurements with torsional mode showed an improvement of about six times in sensitivity and about fifteen times in resolution compared to the first flexural mode. When the empty channel was filled with liquids of different viscosity, the quality factor of the first flexural mode remained overall constant with a variation below 3.3% between the fluids, and confirming the inherent property of suspended microchannel resonators. However, it significantly decreased for second flexural and torsional modes. No noticeable difference was observed in the quality factor between different liquid viscosities for all modes.