Concentrating Ammonium

Master Thesis (2017)
Author(s)

Christiaan Hordijk (TU Delft - Civil Engineering & Geosciences)

Contributor(s)

H. Spanjers – Mentor

JB Van Lier – Graduation committee member

Sebastiaan G. J. Heijman – Graduation committee member

Fokko Mulder – Graduation committee member

Niels Van Linden – Graduation committee member

Faculty
Civil Engineering & Geosciences
Copyright
© 2017 Chris Hordijk
More Info
expand_more
Publication Year
2017
Language
English
Copyright
© 2017 Chris Hordijk
Graduation Date
26-09-2017
Awarding Institution
Delft University of Technology
Project
N2kWh
Faculty
Civil Engineering & Geosciences
Reuse Rights

Other than for strictly personal use, it is not permitted to download, forward or distribute the text or part of it, without the consent of the author(s) and/or copyright holder(s), unless the work is under an open content license such as Creative Commons.

Abstract

This thesis provided an overview of the achievable ammonium concentrations, and the energy used to achieve these concentrations, by ion exchange, electrodialysis and reverse osmosis. The need for this overview arose during research for the N2kWh project, where one step in the process focused on increasing the ammonium concentration of (anaerobic digestion) reject water. The research presented some knowledge gaps. As available reports focused on the ammonium removal from the solution, the concentration in the residual stream was barely mentioned. Even when concentrations were reported, the conditions between the discussed technologies made it hard to make a comparison between the three technologies. Even less was reported on the energy that was needed to achieve the various concentrations.

To compare the three technologies, a 1.5 g NH4+/L solution was used as feed water for all three technologies. The technologies used different techniques to increase the ammonium concentration (using zeolites, electrical current over a membrane or high pressure through a membrane). This made comparing the technologies, very difficult. By using the same feed water for all experiments, the achieved concentrations and the energy that was used in the process could be used to compare the three technologies.

The highest ammonium concentration that was achieved during the experiments (7.1 g NH4+/L) was produced by Electrodialysis. Ion exchange achieved a concentration of 6.0 g NH4+/L, while a laboratory scale Reverse Osmosis achieved 4.5 g NH4+/L. The amount of energy used by the three technologies to produce 6 g NH4+/L was: ion exchange = 0.24 kWh, electrodialysis = 6 kWh, reverse osmosis = 4 kWh (per m3 of produced concentrated NH4+ solution). ROSA software was used to estimate energy use for Reverse Osmosis to achieve 6 g NH4+/L (as the laboratory scale Reverse Osmosis was unable to provide sufficient pressure to achieve this concentration). So ion exchange was the most energy efficient, but the maximum achievable ammonium concentration was the lowest of the three technologies. Electrodialysis was able to achieve the highest ammonium concentration but was less energy efficient and used more energy in the process.

Files

MSc_Thesis_C._Hordijk.pdf
(pdf | 3.25 Mb)
- Embargo expired in 26-09-2018
License info not available