Estimation of rotor effective wind speeds using autoregressive models on Lidar data

Estimation of rotor effective wind speeds using autoregressive models on Lidar data

Giyanani, A.H. (TU Delft Wind Energy)
Bierbooms, W.A.A.M. (TU Delft Wind Energy)
van Bussel, G.J.W. (TU Delft Wind Energy)

2016

Lidars have become increasingly useful for providing accurate wind speed measurements in front of the wind turbine. The wind field measured at distant meteorological masts changes its structure or was too distorted before it reaches the turbine. Thus, one cannot simply apply Taylor's frozen turbulence for representing this distant flow field at the rotor. Wind turbine controllers can optimize the energy output and reduce the loads significantly, if the wind speed estimates were known in advance with high accuracy and low uncertainty. The current method to derive wind speed estimations from aerodynamic torque, pitch angle and tip speed ratio after the wind field flows past the turbine and have their limitations, e.g. in predicting gusts. Therefore, an estimation model coupled with the measuring capability of nacelle based Lidars was necessary for detecting extreme events and for estimating accurate wind speeds at the rotor disc. Nacelle-mounted Lidars measure the oncoming wind field from utpo 400m(5D) in front of the turbine and appropriate models could be used for deriving the rotor effective wind speed from these measurements. This article proposes an auto-regressive model combined with a method to include the blockage factor in order to estimate the wind speeds accurately using Lidar measurements. An Armax model was used to determine the transfer function that models the physical evolution of wind towards the wind turbine, incorporating the effect of surface roughness, wind shear and wind variability at the site. The model could incorporate local as well as global effects and was able to predict the rotor effective wind speeds with adequate accuracy for wind turbine control actions. A high correlation of 0.86 was achieved as the Armax modelled signal was compared to a reference signal. The model could also be extended to estimate the damage potential during high wind speeds, gusts or abrupt change in wind directions, allowing the controller to act appropriately under extreme conditions.

http://resolver.tudelft.nl/uuid:240700bd-8359-4810-b913-ce795d26bf0f

https://doi.org/10.1088/1742-6596/753/7/072018

1742-6588

Journal of Physics: Conference Series, 753

TORQUE 2016: 6th International Conference "The Science of Making Torque from Wind", 2016-10-05 → 2016-10-07, Technische Universität München (TUM), Campus Garching, Munich, Germany

Institutional Repository

journal article

© 2016 A.H. Giyanani, W.A.A.M. Bierbooms, G.J.W. van Bussel