Early-age creep of 3D printable mortar

Early-age creep of 3D printable mortar: Experiments and analytical modelling

Chang, Z. (TU Delft Materials and Environment)
Liang, M. (TU Delft Materials and Environment)
Xu, Y. (TU Delft Materials and Environment)
Wan, Z. (TU Delft Materials and Environment)
Schlangen, E. (TU Delft Materials and Environment)
Šavija, B. (TU Delft Materials and Environment)

2023

In this study, an experimental setup to characterize the early-age creep of 3D printable mortar was proposed. The testing protocol comprises quasi-static compressive loading-unloading cycles, with 180-s holding periods in between. An analytical model based on a double power law was used to predict creep compliance with hardening time and loading duration as inputs. Subsequently, this analytical model was validated by comparison to uniaxial compression tests in which loading is increased incrementally, i.e., in steps, showing a good quantitative agreement. Minor differences between the two results were noted, most notably at the beginning of the test. This is because the determination of creep compliance for 3D printable mortar at fresh stage depends on the load level. In the end, the volumetric strain of tested samples from uniaxial compressive test is used to explain why the compressive loading affects the creep deformation.

3D printable mortar
Creep compliance surface
Early-age creep
Loading-unloading cycles
Volumetric strain

http://resolver.tudelft.nl/uuid:b6368bcd-9a8d-4a57-ade3-e8190f127ef9

https://doi.org/10.1016/j.cemconcomp.2023.104973

0958-9465

Cement and Concrete Composites, 138

Institutional Repository

journal article

© 2023 Z. Chang, M. Liang, Y. Xu, Z. Wan, E. Schlangen, B. Šavija