Optimisation of a-Si:H/μc-Si:H Tandem Solar Cell on Flexible Al Substrates

Optimisation of a-Si:H/μc-Si:H Tandem Solar Cell on Flexible Al Substrates: Use of Modelling for Cell Design and Performance Predictions

Spaans, E.M. (TU Delft Applied Sciences)

Smets, A.H.M. (mentor)
Limodio, G. (mentor)
Houtepen, A.J. (mentor)
Santbergen, R. (mentor)

Delft University of Technology

Applied Physics

FlamingoPV

2020-06-10

The future of our energy supply cannot continue to depend on the use of exhaustible fossil fuels. The successful transition to a society powered by renewable energy sources is one of the major challenges our current generation faces. Renewable systems will only fully establish themselves if high conversion efficiencies can be obtained at a reasonable cost, in order to compete with conventional, carbon-based sources. With this in mind, photovoltaic solar energy can be a promising solution.
This study focuses on the investigation of the potential efficiency of a thin-film tandem solar cell, combining amorphous silicon and microcrystalline silicon for a high performance device. With the use of flexible, light substrates, inexpensive modules can be manufactured in a roll-to-roll configuration to produce high efficiency products for a large scale implementation in society. The semiconductor modelling software ASA was used to optimise the structure of the tandem, identifying the absorber layer thicknesses that maximise the efficiency. Moreover, the impact of possible optical variations in the design of the device on the performance were analysed.
To start, model parameters of single-junction amorphous silicon and microcrystalline silicon cells were calibrated to recreate the performance of such devices based on experimental data. By conducting a sensitivity analysis of the model parameters, this was effectively achieved. The single-junction models were combined in a tandem structure to forecast the operation of the multi-junction device.
It was found that the performance of the tandem was highly sensitive to the choice of refractive indices of the layers at the junction between the two subcells. A high mismatch
between the refractive indices of these layers and the absorber layers of the subcells results in an increased reflection of light to the top cell. This is beneficial for the current production of this subcell, but is too detrimental for the operation of the bottom cell. By bringing the refractive indices closer together, an efficiency of 13.0% was predicted. The inclusion of an encapsulation at the front of the cell boosts this efficiency to 13.7%, at a top/bottom absorber layer thickness combination of 160 nm/0.6 µm.
The possibilities of enhancing the efficiency with an intermediate reflector were examined. The optical conditions for the ideal light distribution with such a reflector were
computed to provide estimations of the potential increase in performance. For the best performing device, an increase of the initial efficiency of 13.0% to 13.2% was foreseen, at slightly thinner top cells and similar bottom cell thicknesses.
All in all, the predicted efficiencies of the amorphous silicon/microcrystalline silicon tandem solar cell evidences the potential of these devices for the production of cheap,
highly efficient modules. The developed analysis of the ideal intermediate reflector can be generalised to other multi-junction solar cells to establish the potential efficiency increase such a layer brings along. This can help in the decision of whether the increase in performance justifies the added manufacturing complexity and costs.

Thin-film silicon solar cells
Flexible substrate
Aluminium substrate
Multi-junction device
a-Si:H
nc-Si:H
ASA
Modelling

http://resolver.tudelft.nl/uuid:bcb4aaac-73dd-4230-8cf7-3324207fb1c2

Student theses

master thesis

© 2020 E.M. Spaans