Measuring Daylight: the New European Standard and the effect on Green Building Certificates

Measuring Daylight: the New European Standard and the effect on Green Building Certificates: A study about the effect of EN-17037 on green certificates

Schouws, Tim (TU Delft Architecture and the Built Environment)

Brembilla, E. (mentor)
Nourian, Pirouz (mentor)
Heintz, John L. (graduation committee)
Azadi, S. (graduation committee)
Forouzandeh Shahraki, N. (graduation committee)
Stoter, J.E. (graduation committee)

Delft University of Technology

Architecture, Urbanism and Building Sciences | Building Technology

2022-06-22

In 2018, a new standard was released for daylight in buildings: EN 17037. This is the first standard for daylight in buildings for Europe. In the Netherlands it will replace the NEN 2057. The determination method for daylight provision for EN 17037 is based on internal illuminance. Additional ambitions for the design quality factors: view, direct sunlight and the prevention of glare have been added to the standard. A sustainable design is all about balancing daylight performance and energy consumption. Large windows will cause the building to overheat and use too much cooling energy. Too small windows will result in low levels of daylight availability and visual comfort. For this reason, it was still unclear whether it is possible to achieve these new recommendations for daylight and at the same time meet the energy requirements for Green building certificates, such as BREEAM and LEED. The main aim of this research was therefore to investigate how much influence the European standard has on the energy consumption of a typical office building and whether the requirements for BREEAM and LEED can still be met.
The analysis shows that the European standard has an influence on the daylight and energy credits for BREEAM and LEED. For the daylight credits this standard has a positive influence. For the minimum performance level for daylight provision for the European standard this is not yet enough to meet the requirements for daylight provision for BREEAM and LEED. For BREEAM and LEED, the variants only meet the requirements if the medium and high recommendation levels for the European standard are met. However, the ASE is often too high for a design that meets the high performance level for EN 17037. It should also be taken into account that when a certain performance level for daylight provision has been achieved for the European standard using method 2 (based on internal illuminance per hour for a typical year) this same variant will usually score lower with method 1 (based on daylight factors).
The energy consumption goes up when the recommendation level for the European standard is higher. When comparing the average energy consumption of variants with the minimum performance level for the European norm with the high performance level, the total energy consumption goes up 8.33 kWh/m2 . These values can be higher or lower with different orientations. To reduce the negative impact of the European standard on BREEAM and LEED, certain parameters for the design can be chosen differently. The most important parameters for meeting the high-performance level and minimizing primary fossil energy consumption is the window-to-wall ratio and width/depth ratio. To find a balance between daylight and energy consumption, the optimal width/depth ratio is between 1.33 and 0.75. The optimum window-to-wall ratio is between 40% and 60%. To reduce the cooling consumption and ASE even more, designers can consider the introduction of overhangs in the façade, or other interventions that reduce the window SHGC.

EN 17037
BREEAM
LEED
Daylight provision
Energy consumption

http://resolver.tudelft.nl/uuid:c78ad7cd-2ba2-4abe-abab-d7b8b97f1736

Student theses

master thesis

© 2022 Tim Schouws