Searched for: +
(1 - 20 of 59)

Pages

document
Duffy, K. (author), Gavin, Kenneth (author), Korff, M. (author), de Lange, Dirk (author), Roubos, Alfred (author)
Three driven precast, four driven cast-in-situ, and four screw injection piles were installed and tested in dense to very dense sand at a site in the Netherlands. Each pile was instrumented with two types of fiber optic sensors and tested under axial compression. Through these tests, a comparison could be made of how different installation...
journal article 2024
document
van Riet, T.C.T. (author), de Graaf, W.M. (author), de Lange, Jan (author), Kober, J. (author)
Being one of the oldest en most frequently performed invasive procedures; the lack of scientific progress of tooth removal procedures is impressive. This has most likely to do with technical limitations in measuring different aspects of these keyhole procedures. The goal of this study is to accurately capture the full range of motions during...
journal article 2023
document
Duffy, K. (author), Gavin, Kenneth (author), de Lange, D.A. (author), Korff, M. (author)
This paper describes axial load tests on three full-scale driven precast piles in the Netherlands. The piles were founded in dense to very dense river-deposited sands, a soil that is widespread across the Dutch North Sea sector. The deposit is characterised by cone penetration test (CPT) tip resistances of up to 90 MPa and offers a detailed...
conference paper 2023
document
Wesdorp, J.J. (author), Grünhaupt, L. (author), Vaartjes, A. (author), Pita-Vidal, Marta (author), Bargerbos, A. (author), Splitthoff, L.J. (author), Krogstrup, P. (author), van Heck, B. (author), de Lange, G. (author)
Josephson junctions in InAs nanowires proximitized with an Al shell can host gate-tunable Andreev bound states. Depending on the bound state occupation, the fermion parity of the junction can be even or odd. Coherent control of Andreev bound states has recently been achieved within each parity sector, but it is impeded by incoherent parity...
journal article 2023
document
Yost, Kaleigh M. (author), Martinelli, M. (author), Yerro, Alba (author), Green, Russell A. (author), de Lange, Dirk A. (author)
Cone penetrometer tests (CPTs) are used to characterize soil for a variety of geotechnical engineering applications, including earthquake-induced liquefaction triggering assessment. Numerical modeling of CPTs is frequently used to better understand soil behavior, soil-penetrometer interaction, and engineering estimates made from CPT data....
journal article 2023
document
de Graaf, W.M. (author), van Riet, T.C.T. (author), de Lange, J. (author), Kober, J. (author)
Surprisingly little is known about tooth removal procedures. This might be due to the difficulty of gaining reliable data on these procedures. To improve our understanding of these procedures, machine learning techniques were used to design a multiclass classification model of tooth removal based on force, torque, and movement data recorded...
journal article 2022
document
Wang, Q. (author), Khosropanah, P. (author), Van Der Kuur, J. (author), de Lange, G. (author), Audley, M. D. (author), Aminaei, A. (author), Ilyas, S. (author), van der Tak, F.M. (author), Gao, J.R. (author)
We demonstrate multiplexed readout of 43 transition edge sensor (TES) bolometers operating at 90 mK using a frequency division multiplexing (FDM) readout chain with bias frequencies ranging from 1 to 3.5 MHz and a typical frequency spacing of 32 kHz. We improve the previously reported performance of our FDM system by two important steps....
journal article 2022
document
Duffy, K. (author), Gavin, Kenneth (author), de Lange, Dirk (author), Korff, M. (author)
Stresses generated from pile installation are a critical component in understanding pile behaviour. These are known as residual stresses and in Delft, the Netherlands, the response of three driven precast piles founded in sand was measured using distributed fibre optic sensing as part of a series of full-scale static load tests. The...
conference paper 2022
document
Duffy, K. (author), Gavin, Kenneth (author), Askarinejad, A. (author), Korff, M. (author), de Lange, D.A. (author), Roubos, A.A. (author)
Large areas of the Netherlands are dominated by deep, soft soil deposits, posing a challenge to engineers with respect to the design of axially loaded foundations. The design of these foundations is primarily based on methods which use cone penetration test (CPT) parameters, such as that outlined in the Dutch national standard NEN 9997-1. A...
conference paper 2022
document
Wang, Guanzhong (author), Dvir, T. (author), van Loo, N. (author), Mazur, G.P. (author), Gazibegovic, Sasa (author), Badawy, G.H.A. (author), Bakkers, Erik P.A.M. (author), Kouwenhoven, Leo P. (author), de Lange, G. (author)
The lowest-energy excitations of superconductors do not carry an electric charge, as their wave function is equally electron-like and hole-like. This fundamental property is not easy to study in electrical measurements that rely on the charge to generate an observable signal. The ability of a quantum dot to act as a charge filter enables us...
journal article 2022
document
Beuling, M.G. (author), van Riet, T.C.T. (author), van Frankenhuyzen, J. (author), van Antwerpen, R. (author), de Blocq van Scheltinga, S. (author), Dourleijn, A.H.H. (author), Ireiz, D. (author), Streefkerk, S. (author), van Zanten, J.C. (author), de Lange, Jan (author), Kober, J. (author), Dodou, D. (author)
The need for a training modality for tooth extraction procedures is increasing, as dental students do not feel properly trained. In this study, a prototype of a training setup is designed, in which extraction procedures can be performed on jaw models and cadaveric jaws. The prototype was designed in a way that it can give real-time feedback on...
conference paper 2022
document
van Riet, T.C.T. (author), Chin Jen Sem, Kevin T.H. (author), Ho, Jean Pierre T.F. (author), Spijker, René (author), Kober, J. (author), de Lange, Jan (author)
Objectives: To provide dental practitioners and researchers with a comprehensive and transparent evidence-based overview of physical robot initiatives in all fields of dentistry. Data: Articles published since 1985 concerning primary data on physical robot technology in dentistry were selected. Characteristics of the papers were extracted...
review 2021
document
Wang, Q. (author), Khosropanah, P. (author), Van Der Kuur, J. (author), de Lange, G. (author), Audley, M. D. (author), Aminaei, A. (author), Ridder, M.L. (author), Van Der Linden, A. J. (author), Bruijn, M. P. (author), Gao, J.R. (author)
We demonstrate multiplexing readout of 60 transition edge sensor (TES) bolometers operating at 90 mK using a frequency division multiplexing readout chain with bias frequencies ranging from 1 to 3.5 MHz and with a typical frequency spacing of 32 kHz. The readout chain starts with a two-stage SQUID amplifier and has a noise level of 9.5 pA/ Hz...
journal article 2021
document
van Gelder, P.H.A.J.M. (author), Taebi, B. (author), van Ommen, J.R. (author), van de Poel, I.R. (author), Asveld, L. (author), Balkenende, R. (author), Hollmann, F. (author), van Kampen, E. (author), Krebbers, R.J. (author), de Lange, J. (author), Terwel, K.C. (author), Visser, Eelco (author)
In this paper, we provide an overview of how Safe-by-Design is conceived and applied in practice in a large number of engineering disciplines. We discuss the differences, commonalities, and possibilities for mutual learning found in those practices and identify several ways of putting those disciplinary outlooks in perspective. The considered...
journal article 2021
document
van Riet, T.C.T. (author), Chin Jen Sem, Kevin T.H. (author), Ho, Jean Pierre T.F. (author), Spijker, René (author), Kober, J. (author), de Lange, Jan (author)
Objectives: To provide dental practitioners and researchers with a comprehensive and transparent evidence-based overview of the characteristics of literature regarding initiatives of robot technology in dentistry. Data: All articles in which robot technology in dentistry is described, except for non-scientific articles and articles containing...
review 2021
document
de Lange, Danny (author), van den Dobbelsteen, J.J. (author), Moelker, Adriaan (author), van de Berg, N.J. (author)
This literature review was conducted to evaluate liver biopsy adequacy, including total core length (TCL), number of portal tracts (PT), fragmentation, and complication rates, as a function of needle type and gauge. A systematic electronic search was performed in the Web of Science and Google Scholar databases, according to the PRISMA...
journal article 2020
document
Bargerbos, A. (author), Uilhoorn, W. (author), Yang, C. (author), Krogstrup, Peter (author), Kouwenhoven, Leo P. (author), de Lange, G. (author), van Heck, B. (author), Kou, A. (author)
Isolation from the environment determines the extent to which charge is confined on an island, which manifests as Coulomb oscillations, such as charge dispersion. We investigate the charge dispersion of a nanowire transmon hosting a quantum dot in the junction. We observe rapid suppression of the charge dispersion with increasing junction...
journal article 2020
document
Pita-Vidal, Marta (author), Bargerbos, A. (author), Yang, C. (author), van Woerkom, D.J. (author), Pfaff, W. (author), Haider, S.N. (author), Krogstrup, Peter (author), Kouwenhoven, Leo P. (author), de Lange, G. (author), Kou, A. (author)
Hybrid superconducting circuits, which integrate nonsuperconducting elements into a circuit quantum electrodynamics (cQED) architecture, expand the possible applications of cQED. Building hybrid circuits that work in large magnetic fields presents even further possibilities, such as the probing of spin-polarized Andreev bound states and the...
journal article 2020
document
Wang, Qian (author), Audley, Michael D. (author), Khosropanah, Pourya (author), van der Kuur, Jan (author), de Lange, Gert (author), Aminaei, Amin (author), Boersma, Dick (author), van der Tak, Floris (author), Gao, J.R. (author)
The SPICA-SAFARI instrument requires extremely sensitive transition edge sensor (TES) arrays with a noise equivalent power of 2×10-19W/Hz and a readout system with an output noise that is dominated by the detector noise. It is essential to ensure the frequency domain multiplexing (FDM) readout system in SAFARI meets the noise requirement. The...
journal article 2020
document
Poursaeidesfahani, A. (author), Andres Garcia, E. (author), de Lange, M.F. (author), Torres-Knoop, Ariana (author), Rigutto, Marcello (author), Nair, Nitish (author), Kapteijn, F. (author), Gascon, Jorge (author), Dubbeldam, D. (author), Vlugt, T.J.H. (author)
A mathematical model is used to predict adsorption isotherms from experimentally measured breakthrough curves. Using this approach, by performing only breakthrough experiments for a mixture of two (or more) components, one can obtain pure component adsorption isotherms up to the pressure of the experiment. As a case study, the adsorption of...
journal article 2019
Searched for: +
(1 - 20 of 59)

Pages