Electromechanical dynamics analysis of pole-piece rotors in pseudo direct-drive wind turbine generators

This paper analyses the electromechanical dynamics of the pole-piece rotors in a pseudo direct-drive wind turbine generator. The investigated generator has a rated power of 10 MW and was designed in the INNWIND.EU project. One way coupled finite element analysis (FEA) was used to calculate the rotor dynamic defections caused by...

Calculation of PWM-induced rotor-can losses in flooded generators

Improving availability of tidal turbines has been identified as a key area to lower the levelized cost of energy from tides. One of the approaches suggested to achieve high reliability is to use a flooded permanent magnet (PM) generator. Flooded PM generators are designed to operate with a seawater filled stator-rotor gap in the generator. Using...

Sliding mode control with neural network for active magnetic bearing system

A novel controller design procedure is proposed for a 5-degree-of-freedom (DOF) active magnetic bearing (AMB) system, based on sliding mode control (SMC) and neural network (NN). The SMC is used to achieve high robustness and fast response while the NN can compensate unmodeled uncertainty and external disturbance by on-line tuning algorithm. The...

Comparing different materials for rotor-can in flooded generators

Flooded Generators have been proposed as a possible solution to eliminate the risks due to the seal failure, and improve cooling in tidal stream turbine generators. In a flooded generator, the stator-rotor gap is filled with the seawater; this poses a serious corrosion risk to the material inside the generator. For this reason, a can or a...

Fast rotor loss calculations in fractional-slot permanent magnet machines

Permanent magnet machines with fractional slot windings are popular because of their shorter end windings, low cost and ease of manufacturing. On the other hand, fractional slot machines have higher eddy current losses in the rotor magnets and sleeve. An accurate calculation of these losses usually involves a time-stepped finite-element analysis...