Tailored Adhesion Properties of Acrylate Adhesives on Al Alloys by the Addition of Mn-Al–LDH

The goal of this study was to investigate the effect of the structure of Mn-Al layered double hydroxide (LDH) on the adhesion behavior of composite adhesives on two Al alloys (L3005 and L8079). The composite adhesives were made out of the UV-curing Bisphenol A glycidylmethacrylate/triethylene glycol dimethacrylate (BT) as polymer matrix and the...

Highly-conformal sputtered through-silicon vias with sharp superconducting transition

This paper describes the microfabrication and electrical characterization of aluminum-coated superconducting through-silicon vias (TSVs) with sharp superconducting transition above 1 K. The sharp superconducting transition was achieved by means of fully conformal and void-free DC-sputtering of the TSVs with Al, and is here demonstrated in up...

Superconducting High-Aspect Ratio Through-Silicon Vias with DC-Sputtered Al for Quantum 3D integration

This paper presents the fabrication and electrical characterization of superconducting high-aspect ratio through-silicon vias DC-sputtered with aluminum. Fully conformal and void-free coating of 300 μm-deep and 50 μmwide vias with Al, a CMOS-compatible and widely available superconductor, was made possible by tailoring a funneled sidewall...

Explosion hazards of aluminum finishing operations

Metal dust deflagrations have become increasingly common in recent years. They are also more devastating than deflagrations involving organic materials, owing to metals' higher heat of combustion, rate of pressure rise, explosion pressure and flame temperature. Aluminum finishing operations offer a particularly significant hazard from the...

Trace element measurement for assessment of dog food safety

The quality of dog diets depends on adequate ingredients capable of providing optimal nutrition and free of contaminants, for promoting long-term health. Trace elements in 95 samples of dry food for dog puppies (n = 32) and adults (n = 63) of various brands were measured using instrumental neutron activation analysis (INAA). The mass fractions...

The effect of strain on the formation of an intermetallic layer in an Al-Ni laminated composite

In the present work, the influence of strain on phase formation at the Al/Ni interface was investigated during cold roll bonding and annealing. A sandwich sample composed of an Al-Ni-Al stack was cold rolled with reductions in the range of 50% to 90%, followed by annealing at 450 °C for 60 min. The crystallography of the annealed sandwich...

Improvement of mechanical properties of AA6063 aluminum alloy after equal channel angular pressing by applying a two-stage solution treatment

A two-stage solution treatment composed of an initial soaking at 420 °C for 10 min and the second soaking at 500 °C for 10 min was applied to cold-worked AA6063 aluminum alloy samples after equal channel angular pressing (ECAP) for two and four passes. The microstructures and mechanical properties of the samples were compared with those of...

Lithium salts as leachable corrosion inhibitors and potential replacement for hexavalent chromium in organic coatings for the protection of aluminum alloys

Lithium salts are being investigated as leachable corrosion inhibitor and potential replacement for hexavalent chromium in organic coatings. Model coatings loaded with lithium carbonate or lithium oxalate demonstrated active corrosion inhibition and the formation of a protective layer in a damaged area during neutral salt spray exposure. The...

Connection between hot tearing and cold cracking in DC-casting of AA7050: Experiments and computer simulations

Direct-chill (DC) casting is one of the most common methods to produce ingots of high-strength aluminum alloys such as an AA7050. Despite of its superior mechanical properties, this alloy is prone to both hot tearing (HT) and cold cracking (CC) during DC casting. HT form above the solidus while CC occurs below the solidus temperature. CC...