Turbulent flow and friction in a pipe with repeated rectangular ribs

Measurements were conducted in the fully developed turbulent flow in a pipe with internal diameter D at a Reynolds number of Re _D= 1.6 × 10 ⁵ . The pipe walls were equipped with regularly spaced square ribs of relative height h/ D= 0.154 , while the pitch-to-roughness height was varied between p/ h= 1.67 and p/ h= 6.67 ....

Response regimes in the fluid–structure interaction of wall turbulence over a compliant coating

The interaction between a turbulent boundary layer flow and compliant surfaces is investigated experimentally. Three viscoelastic coatings with different material stiffnesses are used to identify the general surface response to the turbulent flow conditions. For the softest coating, the global force measurements show two obvious regimes of...

Large-scale structure transitions in turbulent Taylor–Couette flow

We report on the experimental investigation of the large-scale instantaneous flow structures in turbulent Taylor–Couette flow using tomographic particle image velocimetry. The results indicate three distinct regimes for counter-rotating flow within a shear Reynolds number range of 11000<ReS<47000 . Close to only inner cylinder rotation,...

Deformation of a linear viscoelastic compliant coating in a turbulent flow

We investigate the deformation of a linear viscoelastic compliant coating in a turbulent flow for a wide range of coating parameters. A one-way coupling model is proposed in which the turbulent surface stresses are expressed as a sum of streamwise-travelling waves with amplitudes determined from the stress spectra of the corresponding flow...

Turbulent Spot in Linearly Stable Taylor Couette Flow

The transition from the laminar to the turbulent regime in linearly stable shear flows, for example, pipe and plane Couette flows, occurs abruptly with no precursor. The evolution of turbulent spots has been studied to better understand the dynamics of this transition and the onset of turbulence. These studies have mostly focused on pipe flows...

Turbulent Taylor–Couette flow over riblets: Drag reduction and the effect of bulk fluid rotation

A Taylor–Couette facility was used to measure the drag reduction of a riblet surface on the inner cylinder. The drag on the surfaces of the inner and outer cylinders is determined from the measured torque when the cylinders are in exact counter-rotation. The three velocity components in the instantaneous flow field were obtained by tomographic...

Rowing faster by surface treatment

The largest part of hydrodynamic drag during rowing, sailing or canoeing is the turbulent skin friction (80-90%). Higher velocities can be achieved by reducing the friction drag as a result of surface treatment. This research focuses on the development, characterization, and testing of drag-reducing surfaces, like nano- and micro-structured...

Spatial resolution and dissipation rate estimation in Taylor–Couette flow for tomographic PIV

Experiments on the Flow Field and Acoustic Properties of a Mach number 0·75 Turbulent Air Jet at a Low Reynolds Number

In this paper we present the experimental results of a detailed investigation of the flow and acoustic properties of a turbulent jet with Mach number 0·75 and Reynolds number 3·5 103. We describe the methods and experimental procedures followed during the measurements, and subsequently present the flow field and acoustic field. The experiment...

Vortices, complex flows and inertial particles