Experimental analysis of ballast bed state in newly constructed railways after tamping and stabilizing operation

Before the operation of newly constructed railways, tamping and stabilizing machines should be used to improve the quality of ballast beds. With the expansion of the railway network and increase of speeds and axle loads, higher quality and efficiency for tamping and stabilizing operation are required. However, previous studies did not involve...

A high pressure die cast magnesium alloy with superior thermal conductivity and high strength

Thermal conductivity is a key parameter for high performance material needed for electronic devices. While most commercially used Mg foundry alloys exhibit low thermal conductivities. In this work, we developed an Mg–3RE–0.5Zn alloy that is suitable for high pressure die cast (HPDC) ultrathin wall cellphone components. The thermal...

New innovations in pavement materials and engineering: A review on pavement engineering research 2021

Sustainable and resilient pavement infrastructure is critical for current economic and environmental challenges. In the past 10 years, the pavement infrastructure strongly supports the rapid development of the global social economy. New theories, new methods, new technologies and new materials related to pavement engineering are emerging....

An Efficient Probabilistic Registration Based on Shape Descriptor for Heritage Field Inspection

Heritage documentation is implemented by digitally recording historical artifacts for the conservation and protection of these cultural heritage objects. As efficient spatial data acquisition tools, laser scanners have been widely used to collect highly accurate three-dimensional (3D) point clouds without damaging the original structure and the...

Numerical analysis of the effect of the scan strategy on the residual stress in the multi-laser selective laser melting

The inevitably formed residual stress in the Selective Laser Melting (SLM) process leads to distortion, crack and even delamination of the workpiece. Single laser is commonly applied during SLM processing. However, its productivity is much lower than multiple lasers. In addition, the research of residual stress with multi-laser condition...

Fullerene-like WS₂ supported Pd catalyst for hydrogen evolution reaction

Hydrogen is the most desirable green energy carrier and electrocatalytic hydrogen evolution reaction (HER) from water is a promising route for hydrogen production. The search for efficient, low-cost HER catalysts is a challenging and attracting topic. In this work, we report that inorganic fullerene-like WS₂ supported Pd...

Simultaneous photocatalytic and microbial degradation of dye-containing wastewater by a novel g-C₃ N₄ -P₂₅ /photosynthetic bacteria composite

Azo dyes are very resistant to light-induced fading and biodegradation. Existing advanced oxidative pre-treatment methods based on the generation of non-selective radicals cannot efficiently remove these dyes from wastewater streams, and post-treatment oxidative dye removal is problematic because it may leave many byproducts with unknown...

Recycling of Aluminum from Fibre Metal Laminates

Recycling of aluminum alloy scrap obtained from delaminated fibre metal laminates (FMLs) was studied through high temperature refining in the presence of a salt flux. The aluminum alloy scrap contains approximately mass fraction w(Cu) = 4.4%, w(Mg) = 1.1% and w(Mn) = 0.6% (2024 aluminum alloy). The main objective of this research is to obtain a...

Degradation Behavior of Epoxy Resins in Fibre Metal Laminates Under Thermal Conditions

GLARE (glass fibre/epoxy reinforced aluminum laminate) is a member of the fiber metal laminate (FML) family, and is built up of alternating metal and fiber layers. About 500m2 GLARE is employed in each Airbus A380 because of the superior mechanical properties over the monolithic aluminum alloys, such as weight reduction, improved damage...